I NEED A BOWL GUARD FOR SE 302 - Hobart A200 Stand Mixer

The safety guard lifts up. The link provides the main page which has a link to the manual. AEF025SP Spiral mixer from Doyon Baking Equipment Bakery Equipment...

There are two different splash guards fort he A200.
If you have a 12 quart bowl the splash guard is a part number 438078 and if you have the 20 quart bowl the part number is 438079.
Both parts are available from
http://storefront.whaleyfoodservice.com/.

It's telling you that the bowl guard is open. If the bowl guard is in place and closed then you could have a bad bowl guard switch.
Check www.hobartservice.com for your local Hobart office.

If it has a bowl guard on it then it could be the bowl height switch or the side switch on the contactor. If it does not have a bowl guard then it is more than likely the contactor side switch.Check www.hobartservice.com for your local Hobart office.

If you do not have a bowl guard then it is most likely the side switch on the contactor. If you have a bowl guard, it could be the bowl height switch or the contactor side switch. Make sure there are no loose wire connections before you replace parts. The bowl height switch may just need adjustment.

If it has a bowl guard on it then the problem could be either the bowl height switch or the side switch on the contactor. If it does not have a bowl guard then the side switch on the contactor is the problem. If it has a bowl guard, make sure the bowl lift is operating the bowl height switch. The bowl must be all the way up to operate the bowl height switch.

If it has a bowl guard on it then the problem could be either the bowl height switch or the side switch on the contactor. If it does not have a bowl guard then the side switch on the contactor is the problem. If it has a bowl guard, make sure the bowl lift is operating the bowl height switch. The bowl must be all the way up to operate the bowl height switch.

You would need the bowl guard (have a magnet #13 p 4) to engage with the reed switch (#54 p8) in order to activate the motor circuit. Is it a safety feature. I would not recommend to bypass it.
See IPC for detail
https://feg.hobartcorp.com/resourcecenter/Discontinued%20Product%20Documentation/F34656%20Rev%20B_lk.pdf

no there is not a reset , you must determine if its a control circuit problem which most likely it is , ck bowl guard, bowl hieght switch, control relay

If you remove the bowl guard you will see a magnet that attaches on iy in a white housing.The scews come loose and prevent it from closing the switch.Also the switch which comes out of the top pedestal can be adjusted.Let me know.