How do I fix an image being cutoff on the right side?

The screen on the TV being cut off is coming from something that is called overscaning While with most TV's it will automatically fit the input image to your TV"S screen in some TV'sit might cut off a little part of the screen. The solution to fix overscaning on TV'S will be different on each TV.

You need to reduce those images sizes and fit it to the imaginary line showed , by clicking the cursor you will drag it right at the center of it , right clicking the pictures and re-edit the sizes then save .

There is no cutoff.

You will need to loosen up the right side one revolution, then run the belt at .5 revolution. Watch the belt then retighten the right side slowly until the belt stays in the center. Once its running in the center for at least 1 min without moving over more to right you can stop tightening.

Exercise equipment service Treadmills Ellipticals and Bikes Parts Assembly...

In the 1999 Jaguar xj8 there is a fuel cutoff switch on the passenger side right hand panel to the right of the feet. Reach over the top rear of the small panel and find a soft flexible membrane on the top of the switch and press it until it clicks.if that doesnt work,there is a fuel pump relay in the trunk fusebox that might be the problem. 1998 Jaguar XK8 fuel safety shutoff Bing images

Hello snake
The first place to check is the low pressure cutoff switch, on the a/c
acumulator at the right side firewall. With the engine off and the key on
turn on the a/c to low. Remove the plug from cutoff sw, use a jumper wire to make a connection of the terminals in the plug. If the comp clutch engages, the system needs to be charged(most common) or the
cutoff switch is bad. If the compressor clutch won't engage when jumped you can post again or give us a call and we'll dig deeper into the
system. But I hope this helps. Good luck.

I had this same problem however I was using the Magecolor 7450. I was trying to print a C5 postcard and the right hand side of the document was getting cutoff (aprox 2 in). Changing my Paper-Type settings on the printer from "Postcard" to "Any" magically fixed the problem.

I hate this printer.....

u have bad solder conecction on convergence ic , look for 2 big black pieces , or u may going to need a tv repair tech

Ur convergence is dead,need convergence kit.
U know how to solder right?Tries these websites for convergence kit.Tv Repair World.com,Shopjimmy.com,Ebay.com or Partstore.com

THE TWO MOST COMMON LOCATIONS ARE ON THE PASSENGER SIDE FRONT KICKPLATE UNDER THE GLOVEBOX. OR IN THE REAR OF THE VEHICLE NEXT TO THE JACK AND TIRETOOL. I HOPE THIS HELPS YOU. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK