Question about Pride New Mobility Legend 4 Wheel Scooter

1 Answer

I have a victory pride mobility scooter the battery is fully charged and it won't run I tried to reset but nothing worked

The batteries are only a few months old and when I push the levers to go forward or reverse it doesn't do anything

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Pride Master
  • 10,543 Answers

Have the controller module checked. You can also download the service manual from Pride's website. It has a lot of information in it as well as a complete wiring diagram.

Posted on Feb 24, 2015

Ad

4 Suggested Answers

Anonymous

  • 1 Answer

SOURCE: pride victory Scooter battery charged won't run

Its probably too late to give my opinion, but here goes anyway.
I had a similar problem with my mothers scooter and it turned out to be a faulty connection on the wires leading to the motor. I simply pulled the plastic connection apart, cleaned and lubricated the contacts, refitted the connection and all was well.

Posted on May 13, 2009

Ad
FixinFax

Leroy Elliott

  • 3085 Answers

SOURCE: Forward/Reverse switch not working Revo Pride

Could it be in free-wheel mode. Most Prides have a pull up knob at the rear of the scooter.

Posted on Jun 18, 2009

oregoon

  • 175 Answers

SOURCE: I have a pride victory xl8. Problem - was running

All scooters have a protection system built in to prevent burning up the motor, and the user, should the scooter overheat. It sounds like yours overheated. If the temp. outside was warm to hot, and your weight is near the weight limit for the scooter, and you are taxing the motors over a hill, or unstable terrain, then the scooter goes into "limp home mode", or just enough to get you a bit aways, and then it will turn off. After a few minutes to cool off, it will go again, but shut down fairly quickly because it takes a spell to let the whole transaxle-motor assembly to get cool.

Check your weight, and anything else you may be carrying with you on the scooter. Check the terrain, and incline you are going against. Throttle down for all these occassions. If you overloaded the system at some point, then you may have overheated the brushes. Remove them (2) with a standard screwdriver and see if the copper coil is still flexible and springy. If not, replace it/them.

The damage may already be done, so it may need a new motor/transaxle assembly. An expensive proposition I'm afraid.

Posted on Jul 09, 2009

littleone121

  • 23 Answers

SOURCE: i have a old pride victory 3 scooter working well

It is best to let it charge at least over night, longer if it hasn't been used for a while. It is also good to give them a long workout (Don't completely flatten them though) at least occaisionally. If they get regular and thorough use they will last longer, but extra weight like shopping, or lots of steepish paths will flatten them a lot faster. They are only supposed to last a couple of years, but will go longer if you look after them.

One of the most important things is to find a supplier/repairman you can trust. These are, after all your legs or mode of transport you are talking about.

Posted on May 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Victory pride 2002 won't work?


hi Wendy it sounds like the batteries are so low that they can't even power the horn ?
check the batteries connection and the reset fuse situated at the rear .

regards
Rob

www.gewizrepairs.co.uk

Feb 18, 2017 | Pride Health & Beauty

1 Answer

I have a pride victory scooter we bought used believe it is a 2003. It has new batteries. we used and then parked it may not start back up. Unplugging power to control module and plugging back sometim


Hi there sorry to hear you are having problem, just a few questions
1 How long did you park your scooter up without charging batteries.
2 Did you fully charge batteries before you used it again and was they fully charged as some batteries need more charging time if they have been left.

drop me a line

Pete

PS My advice is do not meddle with control units as they are very costly if you break them.

Oct 09, 2014 | Health & Beauty

1 Answer

Pride Victory 10 3 wheel , batteries fully charged power in and out of circuit breaker no power at controls nothing works all fuses are good no power there ?


If you have no power at the console but your batteries are good, check the connections of front to rear harness between the front/rear frame. If that connection is good, there may be a serious issue going on. For an authorized service technician in your area; please contact Pride Mobility.

Apr 30, 2014 | Health & Beauty

1 Answer

My pride mobility victory scooter will not charge


You must charge each battery individually with an automotive NON automatic style battery charger until each battery has at least 10 bolts each. The scooter charger cannot pull up a battery with less than 10 volts.

Jan 14, 2014 | Pride New Mobility Victory XL 4 Wheel...

1 Answer

My victory 4 mobilty wont charge the green light is very faint/the charger was tested working.so why wont my scooter charge


make sure battery cables are secure at battery terminals and clean.how old are the batteries.If the batteries run down fast they are no good.a good way to test them is put scooter against some thing solid and go forward.If the battery indicator drops to o the batteries are no good.It takes about 10 hours to charge the batteries

Mar 15, 2013 | Pride New Mobility Victory XL 4 Wheel...

1 Answer

Victory 4 pride mobilty scooter,the charger dont seem to charge up the batterys. is the charger faulty.


DID YOU HAVE THE MANUAL? YOU CAN FIND THE RIGHT WAY TO CHARGE IF IT DO NOT CHARGE AT ALL MAY BE BATTERY IS BAD OR IF IT DO NOT CHARGER NOTHING PROBABLY THE PROBLEM IS THE ADAPTER, TRY TEST IT USING VOLTMETER OR POWER TESTER.




CLICK HERE MANUAL

Aug 27, 2012 | Pride Go Go Ultra 4 Wheel Travel Scooter

2 Answers

When I switch my mobility scooter on lights etc all work but no drive


hi, I first suggust you make sure that Freewheel is disengaged,

to test this try to push the scooter forward if it moves forward move the lever ,

Check the Wigwam or throttle controls to make sure they are not loose,

Check for reset switches under the seat or on the steering stem,

Check for car type fuses under the seat.

Jul 23, 2009 | Pride Victory 4 Wheel Mid-Size Electric...

1 Answer

Pride victory mobility scooter


A fully charged battery should be over 12 volts. You may need to change your batteries.

Nov 07, 2008 | Pride New Mobility Legend 4 Wheel Scooter

Not finding what you are looking for?
Pride New Mobility Legend 4 Wheel Scooter Logo

766 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pride Health & Beauty Experts

Rob Hill
Rob Hill

Level 3 Expert

1414 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Pride Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...