Question about Zebra 105SL Thermal Label Printer
Posted by Anonymous on
Go to website below, and download the driver from there unplug device, install software and reboot, at next desktop, NOW plug in the unit and use.
Posted on Mar 23, 2010
When the last label printed is still under the printhead, that means the printer is in "rewind mode". There should be an option for "tear off" mode in the printer driver. This is the mode that pushes the last label printed out to the tear bar. The printer will then "backfeed" when printing the next label. Peel off mode is used if you want to print a label and have it "peeled" off the liner so that you can just pick up the label off the liner and apply it. That takes the rewind option to be installed.
Watch out though, if you are using a label software package, there might be a setting in the label format setup for "tear off" which usually overrides the settings in the printer.
Hope that helps !
Posted on May 06, 2010
SOURCE: Won't print last inch on label
contact tech support for Zebra LP 2844 Thermal Printer.
Posted on Jul 21, 2010
Tips for a great answer:
Aug 31, 2013 | Zebra LP 2844 Thermal Printer
Jun 08, 2013 | Zebra LP 2844 Thermal Label Printer
Aug 23, 2011 | Zebra TLP 2844-Z Thermal Label Printer
Sep 03, 2010 | Zebra LP 2844 Thermal Printer
Jul 01, 2010 | Zebra LP 2844-Z Thermal Label Printer
Mar 23, 2010 | Zebra LP 2844 Thermal Printer
Apr 09, 2009 | Zebra LP 2844 Thermal Printer
Jun 17, 2008 | Zebra LP 2844 Thermal Printer
55 people viewed this question
Usually answered in minutes!