What am i supposed to do when i'm getting error 44:10

Good Afternoon Friend,

I understand you are receiving an E47 when the spin cycle is supposed to start, on your Frigidaire Affinity washer, model# ATF7000E. The E47 code states that the control board of you appliance thinks that the door is open. This could also be a false error code. I suggest resetting your washer, by either unplugging it or shutting the power of at your home's circuit breaker, for 3-5 minutes. Once power is restored, start any cycle. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your appliances status has changed successfully. Hope this is helpful.

-Best Regards-
WP

It's either the printhead or the printhead NTC.

Error code 3 indicate that the control board and the motor are either not communicating.

When that light turns red you have to microsoft usually you will have to send it off.

The problem should be 400((1-(1+.019/12)^-60)/(.019/12))
You can enter it almost exactly as given:
4 0 0 * ( ( 1 - ( 1 + . 0 1 9 / 1 2 ) ^ 6 0 (-) ) / ( . 0 1 9 / 1 2 ) ) ENTER

Make sure you use (-) instead of - to enter the negative number.

If you keep getting scanner errors you are probably going to have to get the scanner/copier assembly replaced.
Get a tech to look at it.
I don't suppose you have a warranty that is active on this printer.

if the error message is error then there is a good chanc ethat your touchpad is bad also might want to check your door gasket to see if it is leaking water into the door latch often the cause of a touchpad issue but would need more info if your getting a def error

HTTP 302 is not an error. It's simply a request for your browser to redirect to another URI. Browers aren't supposed to show you a message, they are supposed to simply follow the redirect. You should try accessing the router interface from a different web browser, such as Firefox.

The scanner does not move - I get an "L" code flashing on the readout - please help???


Jeri

It appears to have been a flash error from the website that i was trying to access.