How do I set camera to print date on each picture I take?

SnapTouch can apply the date to photos. It is one of the major features of the program.

Information is taken out of EXIF data of the photo file that the camera creates during shooting. You can also add any comment using SnapTouch and also apply it onto a shot.

How to Use SnapTouch

If the pictures are the ones you have shot without time and date stamp, you can't add them by your camera then. You only can add them by your computer.

Use a card reader can solve many problems about camera SD card.

The date and time (and a lot more) are stored with every picture in its EXIF metadata. Any photo viewing/editing program should be able to display this data. To print this data, please consult the documentation for whatever program you're using to print your pictures. Depending on the program and printer you may print the date on the image, in the margins, or on the back.

The date stamp only works in "Postcard" resolution. Press the "Func Set" button, then scroll down to the bottom to select postcard resolution. Then press the menu button. Select the "Camera" menu, then scroll down to the the Date Time Stamp selection to turn it on.

This function only works in "postcard" resolution. Press function button, and select postcard (1600 pixel width) resolution.

not on the camera, but you can do it with the software Picture Motion Browser

here is the link
http://support.d-imaging.sony.co.jp/www/disoft/int/pmb/feature/print/print.html

Redefine your camera with defaults, or check if the date is correctly set.

I much cameras, if the date wasnt set properly this deactivates the date on the menu. check it out.

Good luck.

The date will only show up on the picture under a limited set of circumstances on the Canon PowerShot digital cameras, of which the A540 is one. You've probably found the Date function in the menu, but discovered that it was off, grayed out, and skipped over whenever you tried to reset it.

Date stamp will only work in "Postcard" mode. Press the Function button (labeled "FUNC SET"), then press the down button until you reach the Recording Pixels selection (usually labeled "L", but not always). It's probably the bottom onscreen selection. Use the right or left buttons to select Postcard, then press the Function button again.

Press the Menu button and scroll down to Date Stamp. Now you should be able to select "Date" or "Date & Time" with the right or left button. Press Menu again and take your pictures.

1. With power off, press the MODE button to select the DATE mode.
2. Press the zoom out (three trees) button for more than two seconds to enter the date/time set mode.
3. Press the zoom out (three trees) button to select year, month, day, hour, or minute (selected number will flash).
4. Use the zoom in (one tree) button to advance the number.
5. Repeat steps 3. and 4. to set each value.
6. Press the zoom out (three trees) button until the colon (in the hours:minutes) is flashing. When the colon stops flashing, date and time setting is completed.
7. Press the MODE button and the power will switch off.