How can I get my crosley cr2405a out of standby mode?

CROSLEY DIRECTOR CR2405A INSTRUCTION MANUAL ...

https://www.manualslib.com > ... > Director CR2405A

View and Download Crosley Director CR2405A instruction manual online. Director CR2405A turntable pdf manual download.

Crosley Director CR2405C Instruction Manual (Page 2 of 48 ...

https://www.manualslib.com > ... > Instruction manual

View and Download Crosley Director CR2405C instruction manual online. Director CR2405C turntable pdf manual download.

try this
http://www.ebook-download-site.com/crosley_cr2405c_pa_manual
10.June.2015

To manually open CR 248 CD drawer take a butter knife insert it under the drawer and above the "C" in the word CD recorder. I polked around for the button and it opened. Did this several times and it's working now thanks to another post on Fixya.com! Yay!

Usual cases in these record all in one players is the internal small fuse located after the transformer, common issue on these.

make this test. There may be a system lockup caused by static discharge. Unplug the power cord and plug it back in.
God bless you

The problem is in the power supply board, often caused by a defective capacitor that becomes open, cap value is usually around 1000uf and sometimes shows a bulge at top leaking contents, if you are handy with a soldering iron replace part with identical value and voltage rating and observe the polarity.

When it is off and plugged into the wall outlet the standby light will be on. The stadby light will go off when power button is pressed. If not there is poblem that needs service.

You can manually re-enable the Hibernate option via command prompt using these instructions:

1. Click the Start button.
   
2. Select All Programs > Accessories
   
3. Right-click on Command Prompt and select Run as administrator .
   
4. At the command prompt enter
   "powercfg -h ON"
   
5. Close the command prompt window.
   

Hi,
How to Enter Service Mode
1. Turn on the main power switch to place this set in standby
mode. (LED will light in red.)
2. Press the buttons on the commander as follows, and enter
service mode.

PRESS these buttons in sequence

ON SCREEN DISPLAY---> (DIGIT 5) ---> (VOLUME +) --->STANDBY

Method of Cancellation from Service Mode
1. Set the standby mode (Press “ (TV STANDBY)” button
on the commander), then press “ (TV STANDBY)” button
again, hereupon it becomes TV mode.


Thanks