What is error #88

The machine is binding and the extra power needed to turn the mechanics caused the motor to strain. The machine needs cleaning lubricating and timing.

It generally indicates that something is preventing the machine from going through its default sequence when you turn it on. That could indicate a snapped belt or one out of place, thread tangled around the inside of the hand wheel, thread wrapped around or near the tension disks, OR it could indicate that something is still on that shouldn't be one--for instance, if you have to do two things on the machine to get a buttonhole, say, a lever and a dial, only one is on, etc.

The first step is to go to your user's manual (you can download it free at the Singer site if you don't have one), and do each step to set it up, making sure you have done it correctly, and making sure things like the bobbin winder are not half on and half off.

Search for:

Make Model error

How To Fix Singer Futura Error Code 88 Yourself

88 error singer confidence 7465

An older mechanical Bernina? Most likely seized due to dried out oil. Take it for a thorough cleaning and oiling.

If you feel adventurous and have some mechanical ability:
Wheel on right side that controls the needle up and down is very tight...

An 88 error code is a generic one. It could mean that the needle isn't moving properly when the machine is turned on, there could be a problem at the bobbin or the computer for the machine is compromised. When did the error occur (regular sewing or bobbin winding)?

First, make sure that the needle is at the highest point with the hand wheel. Turn the machine off and then back on. Does the needle move to the side and back to the center? If so, then the problem is elsewhere. If the needle didn't move, I'd still recommend that you clean the area under the bobbin case.

If you were winding a bobbin, try a different bobbin. Check for any burs that might block smooth rotation of the bobbin. If you were doing regular sewing, also try a new bobbin. Check the bobbin case and hook areas for lint and clean them out.

If the error still persists, the machine needs to be serviced.

I hope this helps.

Cindy Wells

Does this look like your machine?

JUKI DDL 5530N Manuals

I would try rethreading the machine completely and change to a new needle. If, it is not listed in your manual go to singerco.com and see if it is listed under frequently asked questions. Their customer service is very good, call 1-800-4singer. Good luck, hope it is not a serious problem

I have been having the same thing happen. I just discovered the bobbin winder was in the wind position. I moved it and I am in business again! Hope it works for you!