Remote side hang up - Lexmark X5470 All-In-One InkJet Printer

Hang it out in air.

Check for a live skinned wire or tape wire,the wire had only be twist and taped(red should be battery wire)

Hang the fan and slip the receiver between the space above the hanging ball on the fan. Hunter remote might not work.

Hi Shannon,
You could try with an universal remote. They should be available for reasonable costs. Just write down your tv's product name and type, and check at the nearest tv/audio store if your tv's frequency is included in the band range of the available universal remote.
Hang in there, you'll enjoy your tv again :)

Andre

there is some loose connection in motherboard which caused this hang problem, you need technical assistance to fix this issue

try go to options, default connections windows settings, remote control and un-tick the "blank host screen" try also change resolution settings, it would help if your connections are not that good (both sides) Host & Master side.... Good luck

No you cant change signal strength - try changing the frequency of the remotes you might be getting too much interference from other wireless devices in area. also make sure antenna on base (wire hanging out connected to nothing on one side) is fully extended and not hidden inside or behind anything.
Hope that helps

have you tried running the remote in a differnt resoloution setting, you can get these hangs if the remote conection you are trying to conect to has a massive differnce in resoloution to your screen resoloution, try right clicking what ever software you use, and goto properties then goto compatabilty and set the screen resoloution to 600 by 800 , just a rough guess on your problem , hope it helps

I also have this problem.  The ice that was hanging, when looking in the freezer was the right side ice.  I just releveled the frig or increased the height of the side that was hanging causing the water to level.  It has cut down on the amount of ice or times the ice hangs. 

Make sure the power wires from the ceiling mount are still in the electric box. Then have them come from the side near the screw mounting area. In otherwords, not through the center hole. In the center of the black metal part - there is where you put the reciever. It will fit literally resting on the black metal.