Reset acs 308ec to factory settings - Avaya Partner ACS 308EC (108463001) Expansion Module

Try using a PROGRAMMING port like 10 or 11.

I am not sure what #617 is but the loudspeaker paging access code on the Partner ACS is intercom 70. If no audio is heard from the paging port on a test set when this is dialed then the paging port is defective. There is no programming necessary to enable or disable the loudspeaker paging access code.

Unplug the tV from AC mains socket, and reconnect it to AC mains, after 3 minutes or so. This must reset the settings to factory default.

Your ACS has a known software bug. You need to contact the place you purchased it from. They will need to open a ticket with Avaya TierIII, and they will have to upgrade the firmware of the control unit.

Call in, when you hear the auto attendant or your amilbox, press "*7"
then it is just like sitting at your desk....

Yes, that middle light is the processor. Try powering off, and while power off, push on that middle card so it makes a good connection. Then power back on.

The one with extensions 1-17 is the processor. It is possible the processor took a power hit.

To find out what release it is, on a display phone, press feature 59.

It will display:
Partner ACS R......Let us know

Try powering off, reseat the processor, and both cards. Power on.

If that doesnt work, remove the last 308 card and power up. if still not work, power off and swap the 2 3-8 cards.

Is it the 4th line or the 4th port of the voicemail?

You need to reprogram the voicemail group.
#505, group 7 and enter the extensions where your voicemail is.



www.telemanuals.com