Amana reset The green light will come on but will not fill or start cycle

Laundry Washer or Dishwasher?

If it is a dishwasher, it sounds like the Flood Sensor is stopping the cycle. There is a tray between the floor and the underside of the basin. If it is a Dishwasher, you just need to find the leak and fix it.

For a Laundry washer, it is a problem with the control board and needs professional diagnosis and repair.

control switch failure

Check lid lock

Most likely door lock problem or shift actuator is bad. Both fairly inexpensive and simple to replace.

Hi Garrett, does it show any error code anywhere?

If the green cycle light is flashing on then off, this usually means the cycle is paused. The lid lock should unlock when in pause mode, if not you will need to press and hold the "Pause/Play" button to clear the cycle completely, if there is water in the unit, it will drain first, then unlock the lid and be on standby to start a new cycle. Pleazer Appliance...

My washer will notwork it will not let the lid lock are fill with water

Open the control panel. Unplug the timer and then plug it back in good and firm.
If it does not work correctly after that,
Replace your timer.

1st I checked the power, compressor in garage had tripped the breaker to the washer circuit. This model has no bells or whistles to tell you if the power is on to the unit. Reset the breaker and unit works.
Thanks FixYa