I need a wood 2mt spur for a craftsman Mod #351.217150

Contact Sears to request it - phone numbers and information on their web site.

https://www.searspartsdirect.com/model-number/14923860/0247/0728000.html

Model 14923860 Craftsman 12 INCH LONG BED WOOD LATHE Parts

144959d Lawn Tractor belt 144959 GUARANTEED FIT from SearsPartsDirect

your parts manual,
CRAFTSMAN LAWN TRACTOR Parts Model 917272761 Sears PartsDirect

It almost certainly has a #2MT (#2 Morse Taper) drill adapter. Lower the quill and look for a slot on each side of the quill - that's a knockout slot. Insert a steel wedge into the slot and tap the wedge to force the Morse taper apart.

You can buy replacement Morse taper chucks from any number of woodworking or woodturning supply places, or from metalworking supply places, or eBay. You can get them from Grizzly, Packard, Rockler, Enco, Victor, MSC, Grainger... you can buy them through Amazon, you can get them at Sears.

You can buy the assembly as one unit or as two pieces - the chuck and the adapter. If you buy it as two pieces, be sure that the adapter and the chuck have matching tapers - that's usually a Jacobs taper like a #3JT or a #34JT, for example. It's much easier if you buy one matched unit.

You can get keyed chucks, keyless chucks, and automatic chucks with a #2MT shank.

We just got a sears 469.84044 Tripod. We cannot figure out how to put the handle down for packing? any help? [email protected] thanks

I just got the same lathe from my dad yesterday, without the spur center or center cup. I just found that Harbor Freight sells a Jacobs keyed chuck for $10 (part number 45731 ), which accepts up to a 1/2" shank. You can then use a #2MT live center, which is exponentially more common now than the 1/2"-20.

There are a couple in the Grizzly catalog on page 139. Here's a link to it: http://www.grizzly.com/catalog/2011/Main/139

you should be able to order one from sears. another place to look is ebay. the round plastic thing is to mark with pencil the cut of the blade. put in your sliding miter Gage set at 90 deg. put a piece of wood on it, push forward and cut the wood then slide back and mark the wood position on the plastic. that's the point where your blade cuts

Ignition switch is Part Number 163968

I am not getting either # from sears parts. I deal in Craftsman Belt drive table saw parts. I should have a switch that would work for you. Can you send a picture? [email protected]

Craftsman doesnt carry parts for tools once they hit ten years old. However, you can bypass the switch - that is remove it and just connect the two wires together. Then plug it into any power bar that has a switch.