Question about Hotpoint Ultima WD72 Front Load Washer/Dryer
Posted by Anonymous on
F01 is a motor faulty normally caused by the module,but sometimes thewiring to the motor plug that works loose as its to tight,give them alla good wiggle make sure there all in!
check this link for other error codes of hotpoint machines
Posted on Dec 15, 2008
SOURCE: error code F-08
The meaning of F08 is that the heater relay is stuck or cannot be activated for some reason, this has the effect of stopping the water heater from working.
In order to resolve this the only thing you can do is to test the heater, and see if it is o/k.,if it is , then you there is not much else you can do, except call an engineer.
Hoep this resolves your issue. God Bless.
Posted on Jul 09, 2009
Error F05 indicates pressure switch jammed on full.
Remove lower rear cover of washer.
Locate and remove large black hose fastened to drum.
Remove and clean filter inside hose.
Remove hose onto pump, and check for blockage or obstruction here as well.
This should solve the problem.
Posted on Jan 10, 2010
Tips for a great answer:
Dec 02, 2010 | Hotpoint Washing Machines
Mar 29, 2010 | Hotpoint Ultima WF860 Front Load Washer
Jan 17, 2009 | Hotpoint Ultima WD72 Front Load...
Jan 06, 2009 | Hotpoint Ultima WD72 Front Load...
Dec 15, 2008 | Hotpoint Ultima WD72 Front Load...
Mar 27, 2008 | Washing Machines
27 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: