Not printing please wait a movment

Linkage to the gear box reqires adjustment, look on top of the gear box and watch the movment from forward to neutral, then watch the movment from neutral to reverse thet should have approxamatly the same amount of movement, if not adjust the link rod.

Ok, we're waiting for you to ask a question.

no this isn't normal

I would need a little more info to be more exact but there are a few usual causes for this issue. Bad feed roller (you can here it spinning but paper does not move), bad optical sensor (a faint click, very little paper movment), wrong paper (same as bad optical sensor or might just continue to cycle through paper without printing), bad print head (system acts just like it does when it is printing normally but nothing appears on the page) or bad battery (system tries to print but shuts down almost immediatly even if it is plugged in). You can contact me and give me more info and I would be happy to help.
[email protected] or www.overstockme.com or follow us on twitter at overstockmecom

Hi
The ESC has the ability to have reverse locked out. This is necessary because race tracks require it. Go to the Traxxas web site and download the manual. Reprogram as necessary. Good luck

Cold be blower motor on the way out or something in its circuit (relay, switch resistors)

is there a stem and if so it needs to be removed, there will be a small hole by the crown on hte movment with and arrow pointing to it (most of hte time the arrow is there) push a small screw driver or nail down the whole and then pull the crown the movmemt should fall out, the cover might be part of hte movment, if not should just lift off, let me know if need futher assistance. please rate my answer

Check rudder reference unit wiring

pull the battery

then turn unit on wait until all lights have stopped blinking and you feel no movment inside unit ....now try to open ...hold down eject


NOTE ALWAYS WAIT UNTIL ALL MOVMENT AND LIGHTS HAVE STOPPED .

YOU CAN CAUSE DISK ERRORS NEVER TRY TO OPEN WITH LIGHTS ON
GOOD LUCK

PS I NEED THE SOFTWARE TO DOWNLOAD INTO COMP. DONT KNOW WHAT I DID WITH DISK?

THANKS

to reduce speed, click on start button in windows
allprograms,
control pannel,
select printers and other hardware,
mouse,
carry out the changes u want by reading through the dialog box. when finished click ok