Red light next to green light is on(not flashing), 79 error (does not work)

Engage the deadbolt. Try the guest key. If you get a green light with the deadbolt engaged, under the cover plate, adjust the cam a quarter turn. If you still get the flashing red and green, at the switch by the cam, disconnect the small connector with the red and black wires. Try the guest key. If you get the green light then that little switch next to the cam should be replaced. You will replace the entire plate because the switch is fixed to it.

if using a surge protector, remove it. Then turn off and back on. Has memory been added to your printer?

This is for an 82. Hope it helps.
Constant 12V+Light Green Switched 12V+Yellow/Black Groundn/a IlluminationBlue/Brown Dimmern/a Antenna TriggerOrange/Blue AntennaRight Rear Front Speakers5 1/4" DoorsLeft Front (+)Green Left Front (-)Black/White Right Front (+)White/Red Right Front (-)Black/White Rear Speakers6" x 9" Rear DeckLeft Rear (+)Pink/Red Left Rear (-)Pink/Blue Right Rear (+)Pink/Light Blue Right Rear (-)Green/Red

Hi,
Flashing red light is an error code, please count how many times red light is flashing after long pause and let me know to diagnose possible cause of problem..
Thanks.

The flashing red light indicates the PS3 is overheating. This could be caused by: 1. a short circuit in the Power Supply 2. You may need a new fan or 3. the heatsinks may not be making proper contact with the motherboard chips.
If you don't want to deal with Sony we repair the red light error for $79 including shipping. GATpro PS3 Repair

Look at the light carefully when it is flashing. The yellow light error is easy to mistake for a red light error. If it is indeed just a red flashing light than this is usually an overheating issue. There are 3 main causes for this: 1. Fan has burned out 2. Power Supply has burned out 3. The motherboard has a short circuit
The PS3 will need to be professionally repaired to permanently fix the problem. GATpro Repairs will take care of that error for $79 with free shipping!

Hi,

Turn on unit until the red light flashes and the error code(E 73) shows up on the screen. Next insert toothpicks in the back of the console(while unit is running) into the cooling fans, this is to suppose to overheat the console and start two red lights flashing. Turn off console when this happens(unplug all cords from console) and turn the system back on.

Thank you

There are actually some certain meaning on the red light and green light showing different information to user. The summaries are:
1) Green On, Red Off = Printer Ready.
2) Green Fast-Flashing, Red Fast-Flashing = Printer warm up.
3) Green Fast-Flashing, Red Off = Printer off-line.
4) Green Slow-Flashing, Red Off = Processing Data.
5) Green Off, Red On = Cover Opened, Toner Empty or Developer Unit / Drum unit missing.
6) Green Off, Red Fast-Flashing = Paper Jam or waiting for jam reset.
7) Green Off, Red Slow-Flashing = Paper Empty or Paper tray is not inserted.
8) Green Off, Red Off = Printer power is off.
9) Green Very-Slow-Flashing, Red Off = Printer in sleep mode.
10) Green (any condition above), Red Slow-Flashing = Toner low or paper empty.

So what is your printer condition? Better know what is going on your printer so can solve the problem.

YBC (/\)

erreur79

Only Solution is Re-burn printer firmware.

Mahesh DG, Pune