Antenna Loose I have KOSS Boombox... like-new only slightly used. Went to tighten the antenna and think the screw is stripped as it will not grab. Where can I get another screw as this one is severely itty-***** small. Aldo batteries do not appear to be staying in compartment tightly.. how can this b adjusted?

5 Related Answers

Anonymous

143 Answers

Radio Shack carries various replacements. Make sure you know how your broken one mounts because they can look the same, but there may be a variation that will prohibit you from connecting it. If you can, take the broken one with you to match up. If they do not have it, check with a local electronics shop. They may also have a replacement for you.

Posted on May 22, 2008

Anonymous

752 Answers

SOURCE: CD player on boombox

The laser is dead or damaged. Try swabbing the laser with rubbing alcohol on a Q-Tip, then IMMEDIATELY blowing dry with canned air. If this fails, the laser is dead. If it is a Sony KSS-2xx series laser (try to peek in the laser slot to see the decal on it) you can get replacements online. If not, it's junk.

Posted on Aug 04, 2008

Anonymous

4234 Answers

SOURCE: broken antenna

The Sony part number is: 175422611 and the part is available for $15.95 from tritronicsinc.com or any other Sony parts distributor.

Dan

Posted on Oct 08, 2008

Anonymous

1 Answer

SOURCE: Need replacemet antenna

Try a jeep dealer. They may be able to order one.

Posted on Nov 16, 2008

Anonymous

2 Answers

SOURCE: I purchased a Bosch PB10-CD Radio/CD Boombox and

Go here they are about 3bucks eReplacementparts.com

Posted on Feb 26, 2010

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

I need a new antenna for model #CD-102

Do you think any of these would work?
5results for ghetto blaster replacement antenna

Read full answer

Sep 27, 2014 • Lenoxx Electronics CD-102 Cassette/CD...

0helpful

1answer

How can I buy a new antenna for model sony cfm-165tw

Many boombox antennas are attached by a small screw through the pivot point. This is usually a #1 Phillips screw. Some do not have a swiveling antenna; for these you have to remove the back of the case to get at the attachment screw. Keep the screw; it's guaranteed to fit when you attach the new antenna.

The hard part is finding a replacement. If you have the pivoting/swiveling antenna, the Radio Shack 28" Replacement Telescoping Antenna 270-1405 ($5.99 online) will probably work. You might even be able to use it for a non-pivoting antenna that telescopes into the inside of the case.

Read full answer

Jul 22, 2014 • Sony Boombox Am Fm Tv Weather Band...

1helpful

1answer

Boombox repair

Good work

Read full answer

May 03, 2012 • Sirius Sportster Sp-b1ra Boombox

2helpful

1answer

Need an antenna for my RCA RCD147 radio

any old rabbit ear antenna will do, there's a small screw at base of the antenna un-loosen it and replace it with any antenna.

Read full answer

Jun 11, 2010 • RCA RCD148 CD Boombox

1helpful

1answer

Fm rod antenna

Hi, The antenna can be replace ,in which you have to open the back cover of the appliance and you get the antenna from an electronic shop

Read full answer

May 19, 2010 • TruTech T350B Boombox

8helpful

2answers

Need to disasseble my subx2 boombox to replace the attenna plug found only 3 screws under the handle and its not releasing

After dissassembling my subxr2, I have come to the conclusion that the issue with my antenna not being detected is in the female contact of the antenna's plug, not with the connector in the box (as I expected to find). I have not yet verified this by trying a new antenna. Here is how to dissassemble the box in any case.

Very carefully, with a small very flat screwdriver, remove the front grille of the unit. There are 8 additional screws set in deep holes that need to be removed. Once done, the front panel will pop right off.

The inside of the case is a mess of wires. You do not need to disconnect them if you do not want to.

Pry the grill off the bottom of the box. Remove the 4 screws that hold in the speaker. This will allow you to move the speaker that is in the main body out of the way.

The antenna jack is _not_ a part of the circuit board. If you look into the box, you will see a rectangular cut-out in the edge of the circuit board. There is a wire with a silver connector that is held in place by 2 screws. Remove those screws and you are now holding the antenna jack.

Read full answer

Feb 23, 2010 • Sirius SUBX1 Universal Plug and Play Boom...

0helpful

2answers

My antena wont go down ,and the motor wont go off , even when the car is shut off .

Unplug the harness to the ant.It will not go off,until you replace the whole ant.mass.The gear(plastic)are stripped out,and the motor can not sense that the any.is moving.

Read full answer

Jan 19, 2010 • 1991 Oldsmobile Eighty Eight

0helpful

1answer

The antenna plug is loose. how do I open up the

send it to the suplier

Read full answer

Dec 11, 2009 • Sirius SP-B1 Boombox

0helpful

1answer

Need replacement antenna for jensen audio boombox modelcd-1500

any antenna will work .undo the screw ,slide it out and replace from the swivel point.radio shack has them

Read full answer

Jun 14, 2009 • Jensen CD1500D Cassette/CD Boombox

0helpful

2answers

Need replacemet antenna

Most boomboxes use Screw on antennas (either the antenna itself is threaded or has one screw in a plate at the base). You can buy a replacement at Radioshack for about $5.

Read full answer

Aug 04, 2008 • Jeep JXCMP Cassette/CD Boombox