Problem 5h- sharp 5620n - Sharp AL-1655CS Copier

Dear moses Adongo,
Greeting!
Was the administrator password changed from the factory default setting?
if yes!!
Contact your dealer or nearest SHARP Service Department.
For the factory default administrator password, see "TO THE ADMINISTRATOR OF THE MACHINE" in Quick Start Guide. After changing the password, take special care to remember it.

There is a thermistor open. The thermistor controls the heat temperature. This is found in the fuser{ heat section} of the copier.

replace the developer and use 25 sub 02 to calibrate it

http://argos.scene7.com/is/content/Argos/2580580_R_D001pdf

Here is the customer helpline for this product:

0345 640 0800

Thereer is an 18V charger for another Challenger Extreme drill but I do not know about its use with your designated drill. I notice in the documentation 2 x 1.2 Ah Ni-Cd battery back
-1 x 3-5h charger

Here is a smart charger which is 3-5h:

It shuts off when the batteries are charged.

http://www.uniross.com/products/3-5h-lcd-charger

Hello Sudhir,
The error code H5 means there was at least 5 pages in a row where the paper did not come out of the printer correctly (most likely paper jams. The following manual will direct you on the steps needed to clear the code, please note especially page #8-3
Service Manual SHARP AR 5618 5620 5623 SME
The following video should help also;

have you installed the scanner driver or application on the pc ?
initiate a scan from pc without touching the scan button on the printer

This code either low voltage. otherwise paper jammed frequenty about 3 or more time. we can reset the h5 error by # interrupt C interrupt then 14 and startkey. it will be ok..

Just you need replace toner chip.

i have sharp ar 5620n it is showing error f2-70 what might be the course

Sharp AR-5620N getting f-2 error. What is the solution