Question about Panasonic NV-DS65 Mini DV Digital Camcorder

1 Answer

Help with my panasonic

The camera comes on but when i put vcr mode on the power light flashes twice and the screen stays blank,have bought a new battery for£25 and still have the same problem.
please help
best regards
lee clifford

Posted by doofusman on

Ad

1 Answer

jeff knowles

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 66 Answers

Lee, i had the same problem i think. does the camera turn itself off after 10 seconds or so?? if so you have to check the ribbons on the bottom of camera. there are 5 screws on bottom of camera 2 on the side 1 on the bottom right of the lcd sreen. after all the screws are off check all the connection to the camera, ribbons might have come out a tiny little bit just push them back in make sure you do all of them. doing this fixed my problem hope it helps you. jeff

Posted on Dec 27, 2007

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a canon EOS 400D. a few days ago i dropped the camera. not far, maybe a few inches onto a carpeted floor. ever since then the lcd screen will stay on for a about a second then will go blank then...


A camera is a very complex device so any internal damage would need a proper repair, it may only be a disturbed internal problem but with fiddly screws and the need to keep dust free a good repair place is needed.
As for you just check and refit any items you can like a card or battery etc, if new and bought with a credit card there may be an insurance on it or you can call on or contents policy maybe, as there are lots of policies on new items for a short time in respect of damage claims.
If a cheap cost to purchase and not worth the cost of repair then auction on ebay to recover some money.

Sorry, hope that helps you decide..........

May 08, 2017 | Canon EOS 400D / Rebel XTi Digital Camera

1 Answer

Blank Screen


HI there.
Try booting into safe mode by pressing F8 while the computer starts up.
If you can get it into safe mode perform a system restore.
If it won't boot into safe mode please post back.

Good luck and thanks for choosing FixYa!!

Jun 02, 2009 | Acer TravelMate 4230 Notebook

2 Answers

Problems with Sansui VRDVD4005 DVD Player / VCR Combo.


the only problem i have is the remote reciever works only part time. I bought aa new remote control but didn't help.what do you think the problem is.

Mar 02, 2009 | Sansui VRDVD4005 DVD Player/VCR

1 Answer

Red power light flashes twice and unit will not record. I will not play a tape, none of the tape keys work (rewind, fordward, or pause, etc). I do get a picture in both the vcr and camera mode but the tape...


That is caused by leaking capacitors. Not a lot the layman can do about it except purchase a new camcorder or send it to Panasonic for repair, if not obsolete.

Apr 23, 2017 | Panasonic Palmcorder PV-DV52 Mini DV...

3 Answers

Camera wont turn on


goto http://www.digitalcamrepair.com/self_diagnosis_page.htm
for self diagnosis.please let me help you before leaving a bad feed back.

Apr 30, 2008 | Kodak EasyShare C533 Digital Camera

1 Answer

Blank LCD screen on shooting mode, but does show settings. Will not take pictures. Replaying mode works, shows pictures taken before screen went blank. New batteries. What is going on??? Is it...


The Display button manually turns the LCD display on or off to save batteries. If you accidentally had turned the LCD off, It should only take one press of the button to turn it back on and leave it that way. As such, it's not you but the camera. The A570 IS is relatively new. Your camera is likely still under warranty. If so, contact Canon for warranty repair (see the following link):

http://www.usa.canon.com/consumer/controller?act=PgComSmModDisplayAct&keycode=2113&fcategoryid=221&modelid=14905

Mar 15, 2008 | Canon PowerShot A570 IS Digital Camera

8 Answers

Kodak Easyshare CX7530 won't stay powered on


SOLUTION: Fot the past two years, fully charged NiMH and new alkaline (generic and fresh Name Brand batteries) in my CX7530 always gave a red light and immediate power off -- symptoms of low batteries. Today I tried it again with the same problem. This time, I folded up a small piece of stiff paper to depress the small Lithium battery module detect switch in the battery compartment, and put my NiMH batteries back in -- it WORKED for the first time in two years! After removing the paper and reinserting the batteries, it still works. I suspect this somehow recalibrates the low battery detect circuit. I hope it helps you as well.



Oct 18, 2007 | Kodak EasyShare CX7530 Digital Camera

1 Answer

Screen goes blank when I plug camera into computer


I have to say Mac's I know nothing about. But the simple way would be to purchase a universal USB card reader- and use that.

Jul 04, 2007 | Canon PowerShot A520 Digital Camera

1 Answer

Canon CCD GL1


Hey hill,
This happened to me one time. Judging from the date of this, you probably have found a solution. The bottom line is that the camera has accidentally been placed in "Standby" mode. It is the lever surrounding the back of camera record button. When this is moved to standby, the VCR mode works, but nothing for the Camera mode. Hope this helps.

Oct 10, 2006 | Canon GL1 Mini DV Digital Camcorder

Not finding what you are looking for?
Panasonic NV-DS65 Mini DV Digital Camcorder Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Video Cameras Experts

Kenneth Walker

Level 2 Expert

292 Answers

Cindy Wells

Level 3 Expert

6082 Answers

Pieter Vleeshouwers
Pieter Vleeshouwers

Level 3 Expert

2016 Answers

Are you a Panasonic Video Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...