Question about Hilti Drills

1 Answer

Battery charger red charging light blinks once then goes out

I have tried both batteries with the same result. The green charger light comes on OK but the red light comes on for a second or two the goes out. Both batteries do the same although the red light stays on longer with one battery than the other, about five seconds for one and fifteen seconds the other. Any help will be greatly apprieciated.

Posted by Arthur Evans on

Ad

1 Answer

Don Eagan

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 714 Answers

Do the batteries charge? Are they charged? The green indicator normally is the status signal that the battery is charged and the red indicates that the battery needs charging or is charging. If you plug in a charged battery, some chargers will flash red momentarily then go out. This is an indication that the charger checked the battery (red light) and if the charge is good, the red light will go out. I hope this helps you.

Posted on Oct 24, 2017

Ad

5 Related Answers

Anonymous

  • 384 Answers

SOURCE: 14.4V Drill Battery Will not Charge

The battery is 14.4 volts so the charger should be 14.4 volts.

Posted on Jun 26, 2009

Ad

Anonymous

  • 205 Answers

SOURCE: have 24v sds drill older type the one with the

not sure on the charge well have to check out but contact a interstate battery shop thy can rebuild most batteries

Posted on Oct 13, 2009

Donald B Stoll

  • 597 Answers

SOURCE: battery charger doesn't charge. light blinking

Plug in the charger and then being careful to only touch one contact with one lead use an ohm/voltage meter to check the voltage and see if the charger is putting out any voltage.

Posted on Nov 29, 2009

radar001

Bob Korsu

  • 1051 Answers

SOURCE: Charger light flashes with no battery charging. I

The charger is damaged. Return it to the place of purchase and demand a refund or replacement. If you paid by credit card call the credit card company and cancel that transaction.

Posted on Feb 25, 2010

radar001

Bob Korsu

  • 1051 Answers

SOURCE: My battery will not charge. ( Ryobi 18.0v)

Bothights on indicates a problem with the battery. You cam try cleanibg the battery terminal with a Q-tip moistened with alcohol. Allow it to dry completly before tryin to recharge. If that doesn't work the battery may be defective or broken. If it was dropped that could cause the damage.

Posted on Mar 10, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My battery charger is blinking geen not red when I’m trying to charge it. What does that mean?


Hi Linda.
not sure if this will help you out,i found this on the internet.
Battery Charger Troubleshooter
When there is a battery failure, there is a possibility it was caused by a bad battery charger. When the charger is only plugged into the wall, it should show a green light. If there is no light showing, confirm that the outlet is good. If the outlet is good, it is very possible that the issue is with the battery charger, not the battery.
If the charger is plugged into the battery only, it should show a green light. (If you have purchased a new charger within the last year, you will not get a green light if the charger is only plugged into the battery. You will get a green light however if the wall charger is just plugged into the wall and not plugged into the wiring harness) If it does not show a green light, it is likely that the charger is not making contact with the battery. The most likely reason for this is a faulty fuse on the wiring harness. This fuse is a 2-amp automotive fuse, and it should be replaced with a 2 or 3-amp fuse available anywhere that sells auto parts. The fuse can blow out if there is a short in the charging system, or if the plug-in end of the wiring harness comes in contact with a battery terminal.
When the charger is plugged into both an electrical outlet and the battery, there should be a red light showing on the charger. A red light showing indicates that the charger is in contact with the battery and is actively charging the battery. Once the battery has reached a voltage level that is considered "fully charged" the red light changes to green. If after 24 hours the light has not changed to green there is no cause for alarm! Remember that when the light is red, the battery is being charged, and you will be able to use your system. After 24 hours or so, your battery is as charged as it is going to get, and if the light is still showing red you should disconnect the charger and go fishing. Replacement chargers and parts can be purchased directly from MarCum's website.
If you are really concerned about your battery, consider getting a basic volt meter to check the voltage of your battery. They can be bought for less than 20 dollars and will show you exactly what the voltage level of your battery is. If after 24 hours of charging your battery should have at least 12 volts (ideally 13-14 volts) and as long as it is over 12 volts it will work. If it is not at or above 12 volts you should consider replacing the battery. If your unit starts to malfunction while you are fishing, it would not come as a surprise that the voltage has dropped down to 11 volts or lower.
If the charger is plugged into the wall and battery, and you get a blinking light on the charger, it is very likely that the battery is faulty and should be replaced.
Batteries are an expendable item, and must be replaced periodically. Any store that sells ice fishing electronics will stock suitable batteries. You can also buy them at a specialty battery store, or by ordering one from our website.The batteries that you should use are the "Sealed Lead Acid" variety, they are 12 volts, and range from 7 to 9 amps. The more amps the battery has the longer it will run on a full charge. Your MarCum unit can be powered off of any battery that is 12 volts, even a large automotive or deep cycle batteries will work.
or go to this link and have a read up.

battery charger is blinking geen Google Search

Jun 14, 2018 | Cameras

1 Answer

Charger not working


When the red light is on it is to indicate that the charger is getting power from the wall outlet. If there is a second light that normally comes on Green when charging pay close attention to it when you first plug the charger in. See if it blinks even once then turns off. If it does that means the charger is not seeing any battery voltage at the plug that goes into the chair. If the green light does not blink at all then it usually means the charger is defective. Also most wheelchair battery chargers will not charge the batteries if the chair is to dead to even turn on.

Apr 12, 2015 | Health & Beauty

1 Answer

What does a orange power light mean


please see the commentary. God bless you

  • The majority of laptops will display a solid green, blue or purple battery light to indicate that the battery is fully charged. Most manufacturers indicate that a laptop is in the process of charging by displaying a solid or blinking green, orange, blue or purple light. If your battery indicator light is green, blue or purple, the battery is probably functional, regardless of whether the light is blinking. If the light is solid orange, the laptop is probably in the process of charging.

Battery Error Coneventions

  • Many battery manufacturers use rapidly blinking lights to indicate that a battery's charge level is low. In general, a laptop will rapidly blink orange or red when its charge drops below a certain level until the computer is plugged into a power outlet and charged. If your laptop's battery indicator continues to blink rapidly in orange or red or if it remains red even when it is plugged into the charger, it indicates a problem with your battery or the charger.


Read more: http://www.ehow.com/info_12183593_blinking-battery-light-laptop-mean-charger-not-charging.html#ixzz2fu5qhEWg

Sep 25, 2013 | Computers & Internet

4 Answers

RYOBI CHARGER RED AND GREEN FLASHING LIGHT


Try rotating the plug that goes into the wall. I know it sounds irrelevant but ive had the same issue and it worked for me. The positive and negative may be reversed in the dock.

Jan 04, 2012 | Ryobi Multi-Volt Battery Charger

1 Answer

NOT CHARGING BATTERIES


ok you need to zap the battery, if you have a jump box or a battery charger that has at least a 20 amp or better charge selection, like a engine start feature.

the post of the cordless batter has a center post marked on the sides is a plus or minus sign.
the should also be some vertical slits in the plastic post on the corners, clamp the leads from the jump box or battery charger positive to positive , negative to negative. with the car battery charger you can probably slip one side of the battery clip in the plastic slot the other on the connection blade. plug in the battery charger and let it on for 5 or 6 minutes. if the battery charger has a auto shutoff the light will blink off and on but that is ok .

take the cables off and plug into the battery pack charger now you should get a red charge light and now can charge the battery.

if light does not come on try it in the drill or saw and see if you had any more charge than before if so you might need to repeat the procedure and leave it on the car battery charger a little longer

Jun 08, 2009 | Ryobi 3-piece 18V Drill / Circular Saw /...

2 Answers

Ryobi lithium batteries won't take charge


For others with the same problem (flashing red light won't go off)...make sure you FIRMLY PUSH the battery down onto the charger and engage the latches. Simply resting the battery on the charger will not work.

Jan 30, 2009 | Ryobi 3-piece 18V Drill / Circular Saw /...

1 Answer

Charger red lite flashing. Camera comes on for one second and shuts off


Hello,
Here's a copy from the owners manual:
■ Charging LED 
Red LED is on = Being charged 
Red LED is blinking = Charging error 
Green LED is on = Carging is complete


● If the charge indicator blinks as red, it indicates a battery charging error.
- The battery is not properly inserted
- The terminals of battery are dirty or damaged
If the battery is inserted properly and the charge indicator continues to blink, contact the
nearest Samsung Camera Service Center.


Another charging error is when the batteries are so depleted, they won't charge up to 100% anymore = red light doesn't go out and remains on for too long, means get a new battery.

Jun 10, 2008 | Samsung Digimax i5 Digital Camera

1 Answer

Battery will not hold a charge.


Casio says:

Red blinking light = defective battery

No flashing light = possible defective charger.

What you can do is send all your stuff into casio and they will test everything for you and see what they could replace for you.

Sep 03, 2007 | Casio Exilim EX-S600 Digital Camera

Not finding what you are looking for?
Drills Logo

Related Topics:

641 views

Ask a Question

Usually answered in minutes!

Top Hilti Drills Experts

Pieter Vleeshouwers
Pieter Vleeshouwers

Level 3 Expert

2028 Answers

Lawrence Oravetz

Level 3 Expert

10548 Answers

Glenn Smart
Glenn Smart

Level 3 Expert

832 Answers

Are you a Hilti Drill Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...