Hot surface indicator light stays on - Hotpoint RB787 Electric Kitchen Range

One of your surface elements is bad (the hot-element switch that is part of the element is stuck on). If each element has its own hot-light, then you know which element is bad; but if you have just 1 hot-surface indicator, your problem is figuring out which element is bad. That takes an electronic technician with patience and an ohmmeter.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

Hi,

Here is a tip that I wrote about why the hot surface indicator light will not go out...

Oven Hot Surface Indicator Light stays on

heatman101

Hi,

Here is a tip that I wrote about the problem of the cooktop light staying on.

Oven Hot Surface Indicator Light stays on

heatman101

Hi,
Here is a tip that I wrote about why the hot surface indicator light will not go out...

Oven Hot Surface Indicator Light stays on
heatman101

signs of a faulty hotplate sensor especially if the surface is cold

mvek,
If you could see through the glass, you'd see "temperature sensors" located near the elements. They're very sensitive little guys, and rightly so! Their job is to detect temps and energize the warning light on the cooktop so users won't get burned.

To answer your question... It appears that there is an issue with the front left sensor (and possibly the right as well). The temp warning lamps should NEVER go off immediately. Please call for warranty repair (1-800-GE-CARES). This is an unsafe condition for you and your Family. The warning indicators are there for a reason and should indicate high temp's as long as high temp's are present.

SG

Your hot surface indicator light might have a short that causes it to stay on all of the time. If you can, try unplugging it for a little while and plugging it back up. If the light is still on, you have a short. You can still use the stove, but the light staying on will not be any help to you.

Each element contains a sensor to detect when the element is hot, this sensor has failed. The element will have to be replaced. If there is only one light to indicate hot surface, you will have to determine which element has failed.

If it's the light that indicated the element is on, replace the switch. If it's the light that indicated the element is hot, replace the element.

The component that controls the hot surface light is part of the element. If there is a light for each element you just replace that element. If there's one for the whole surface or each side you'll have to figure out which element is causing the problem.