P990i touch screen not possible to calibrate

Recalibrating the screen is a rather simple matter on this phone.

Navigate to Control Panel\Other\Setup Wizard

Then, follow the on-screen prompts and you should be good to go.
If problems still persist, it may be possible that you are in need of a new LCD on the handset itself, which can be costly and difficult to install. Take the phone into a professional near you for an estimate.

When the Reader device is started for the first time or is reset back to factory settings, the screen must be calibrated. The Reader device will display a calibration screen that requires you to touch the stylus to the center of an "X" at several points on the screen. This is to make sure the touch screen properly recognizes input.
The process requires you to touch the "X" in the following locations on the screen:

• Top left
• Bottom right
• Top right
• Center

If the screen is accidentally touched someplace other than the center of the "X" during calibration, the Reader device will display a message stating Calibration error detected. Please restart calibration process .
If this happens, please start again in the top left corner and touch the stylus to the center of each "X" as it is displayed, being careful not to touch any other part of the screen. After the sequence is completed the Reader device will display Touch Panel calibration completed . Click OK to continue to the next step in the setup process.

reinstall the operating system and try

you need to replace the touch screen for it.
contact:
Email/MSN:[email protected]
SKYPE:keyudakim
ICQ:597322520
For a solution.

Hello,
Try calibration! else, the only way is to change it, i did it my self, i think it would not be difficult if you have done similar things! you can buy it for a reasonable price on the net. Good luck

me 2

first of all calibrate ur touch
then if not works
please change ur touch pad

you can do it by running setup wizard, located in control panel->others-> setup wizard and follow instructions till you will be asked to tap on blinking points.

Touch screen not working for sony ericsson P990i Mobile phone

When I hit the center some part above gets highlighted and selected and the botton part where the taskmanager and battery icons are present does not respond to my taps ... what could be the problem,,, kindly help me solve the issue.

Praveen

I encountered the same problem but was able to fix it. Just don't know if it's just temporary. Go to tools, control panel, other, set up wizard, tap yes, tap the second button before cancel, keep on clicking to the right direction until the numbers 1, 2, 3 and 4 appears. Tap the center of each number until blinking stops, save settings. For the first few steps you may use the jog dial found on the left side of the phone if the touch screen does not follow your tappings.