Installation driver Where can i find the driver website for my wireless camera with model DCS-950G DLINK

SOURCE: D-Link DCS-G900 Network Camera setup

http://www.dlink.com/products/?pid=270

go here and on the right under support resources select application.

SOURCE: download software

You can download the driver from the following link :
http://driverscollection.com/?file_cid=390169192057c4f19a60c24a889

I hope this will solve your issue.

Good Luck.

If my solution proves useful please accept it.

Regards
Arjun

SOURCE: My DLink 5300 G internet camera suddenly says "No Signal."

1. Remove the Java update and roll it back to the previous state.
2. If it does not resolve the issue, reset the camera.
3. Lightly insert a paper clip or a similar sized object into the reset hole on the back of the camera, press lightly and then release the button.
   
4. The LED on the front of the camera will begin blinking red and green.
5. When the LED stops the blinking, the reset has complete.
6. If the issue is still present, restore the camera to factory settings.
7. Insert the paperclip or other tool and press on the button continuously.
8. Wait for the LED on the front of the camera to blink red and green and hold the button through two cycles of blinking (about 5-7 seconds.)
9. Withdraw the tool after the second cycle of the LED blinking and factory restore has been completed.
10. Run the installation wizard. If you don't have the installation CD, go to the manufacturer's website and download the software.

SOURCE: DLINK - DCS-900w Firmware Update needs install software?

Go to dlink.com. Select IP cameras. At the top is a search using Product Quick Find. Find the 900w and click on it.Select Support Resources. All the firmware and software is there.

SOURCE: how to setup aztech router

Install the installation disk of the ipcamera. Configure the ipcamera base on your requirements. Then install the ipcamera on the position you require.