CANT OPEN FACE TO CHANGE CD

Presuming you are talking about a CD-ROM drive, you should first check your manual for information on operating the drive. There are many ways drive trays may be opened. Sometimes there is a button on the laptop that has the standard symbol for CD eject on it that will open the cd tray. Sometimes, there is a small button on the cd-tray itself that when depressed will cause the tray to open after a small delay. This all presumes that you don't have a tray-less
CD drive, that is just a slot on the side of your laptop. If the CD tray is stuck, because of some problem, look for a small hole on the face of the CD tray. Take a straightened out paper clip and push it gently STRAIGHT into the hole until you feel it stop against a bar. Push just a little harder, and the tray should pop open. This latter procedure should only be used when all other methods have failed to open the CD tray.

Assuming its a fairly new model...when tye unit is on..hold the menu button down until it finally beeps..u may have to hold it for a bit..then scroll through options till u find clock...then depress dial button and set time..then hold dial button to set once complete

My only thought to this would be did you remove the shipping screw from the deck before you installed it? There is usually 1 maybe 2 screws they put in the deck to keep the parts inside stationary while the unit is being shipped.

There is probably another eject button for the cd player on the subpanel behind the face. Usually on the upper left or right hand corner.

first check all of your power and ground connections and be sure your battery is good then try the small reset button on the front face. if that does not work you may need a new flexible ribbon cable that you can find on ebay cheap.

hi, sounds like a switch had become faulty, you will have to send to a repair agent.
www.blueice-electronics.co.uk

That open button should take the whole faceplate off too. Try pulling it from the bottom. hope this is of help. What model of pioneer is it? Mosfet is just the kind of internal amp it uses.
hope it helps!

yes it is a over heting problem

not open the face? or not get on the stereo? if not open the face maybe is too fit on the space for the stereo, check down if have space, if dont get on, check if are well conected

Push the button on the top right corner. It is a little black button that pops out. This should allow for you to bring down the face plate and you can then insert a cd. Hope this helps, also can you please rate my answer. Thanks