I need the component list decause i have some burnt resistors

Without a circuit diagram or another actual unit to look at it is very difficult to identify burnt out resistors. Even harder is finding out why it burnt out because most of the time a resistor only burns out if overloaded due to other circuit component faults.

You can get the value of this resistor from the circuit diagram of your model TV.
Usually a burnt resistor is caused by some other component failing that is connected to the resistor.

My suggestion is to buy a new Clock Radio to replace the one that quit, they are cheap and unless you want to take it apart and service it yourself the cost to fix it would buy a new one.
If you do decide to take it apart then you want to look for burnt resistors on the electronic boards inside the unit. A resistor can be lots of sizes and can be many shapes but just look for a burn on or around all electrical components.
This image Shows a resistor slightly burnt out but burnt nevertheless



This image shows a seriously burnt resistor

Many times when dealing with a burnt component, a resistor for example, you will be able to read the underside of it where the component is not burnt. What is the component, or model of the device?

Good luck!

Hello,
The component is a resistor. The problem is going to be determining the resistors value since it was burnt and you can not see the color code. You might try contacting the manufacturer and asking them the value of that specific resistor by including the number like you did in your post R14. If you can find a wiring diagram for the product, it should tell you the value of the resistor also.

I hope this helps you getting started in solving the issue.

If you would not mind, please rate my help. I would greatly appreciate it. Thank You

There are LIKELY other bad components that caused this. Resistors USUALLY don't fail on their own.

you can try just replacing the resistor, but I'm afraid you have other issues too because of this burnt component

sometimes the component is listed on the circuit board in it's value where it is mounted.
can you read the color bands? if not than a schematic will list it.

You can check out this website for your service information and parts: https://spares.bigwarehouse.com.au/index.php?cPath=24759_24762_24803 Paste the address in to your address bar. That will take you to the website. They had three of the four parts that you needed listed on the website 1.Q706 -Transistor bipolar FJAF5804 (TU) Fairchild $ 49.61 2. C744-Capacitor drawing SM SHR SYE/SWE 160V $ 19.06 3 R809- Resistor fixed small 1 ohm 2W 5% SF. $ 14.27 They also sold the service manual for $ 29.57. I hope this helps you with your problem.

Usually if some parts on the board burnt on that model it can be caused by leaky tubes. Meaning the coolant from the crt's has dripped out. If burnt components are beneath any of the tubes, inspect very closely for liquid substance having leaked down from coolant chambers above. If this has happened you must seal leaky gaskets before going through any trouble of pcb repair.If burnt parts are not below tubes, most common cause is bad convergence ic's. At any rate, service info avail online or at samsung.com or 1800samsung. Hope this helps.