Question about Canon FS400 Camcorder
Posted by Anonymous on
SOURCE: my canon zr400 wont turn on
ITs most likely a fuse, unfortunately you can change it or its a son of a gun to change. You can check by removing the motherboard, locate the fuse, they are micro fuses, it either has the letter H or K etched on it, there could be anywhere from 1-5 of those fuses. Check for continuity if that s the problem than replace it, if you cant find a replacement micro fuse than solder over the fuse for continuity...that should make the camcorder power on, but beware once you solder over the fuse- there will be no more current protection for the camcorder. If the fuse is not the problem than it could be a loose circuit...
Posted on Apr 02, 2008
Some of The Canon Powershot A530 and A540 cameras are subject to an advisory recall. Seems that a small spring on the battery compartment door can short out the batteries. Suspect this of yours, in that you mention that your batteries aren't lasting long. If your camera is on the list, Canon should fix this for you for free, including free shipping both ways. This is regardless of your camera's warranty status. Please check the following link for more info:
Posted on May 28, 2008
SOURCE: camera wont turn on
Camera will not power on. Canon posted a bulletin regarding a possible solution for some SD950's at the following website. Apparently this model has a screw that can come loose inside and the camera will not power. They just found this to be the case with my SD950, and they fixed it for free. It was outside of the warranty by a couple months. They even sent me a prepaid UPS shipping label to send them my camera for repair. See the link below for more on this possible solution:
Posted on Mar 26, 2009
SOURCE: Canon G10 wont turn on
Try removing the card first and then trying to power up the camera. Cameras often fail to turn on/off when a card goes faulty. Next I would try pushing the playback button, it also acts as a power button but starts the camera in playback mode. If this works it could indicate a problem with the power switch circuit itself. If there is still no sign of life I would suspect a fuse to have blown. They are internally located and very small, you would need to have a service centre try replace it for you. Good Luck!
Posted on Apr 15, 2009
Tips for a great answer:
Sep 08, 2014 | Canon PowerShot SX500 IS Digital Camera -...
Aug 10, 2014 | Canon FS400 Camcorder
Dec 02, 2013 | Canon FS400 Camcorder
Apr 17, 2010 | Canon PowerShot SD750 / IXUS 75 Digital...
Mar 05, 2010 | Canon PowerShot SD1000 Digital Camera
Nov 16, 2009 | Canon PowerShot SD1100 IS Digital Camera
Jun 30, 2008 | Canon PowerShot SD630 Digital ELPH / IXUS...
Jun 23, 2008 | Canon IXUS 960 IS Digital Camera
May 27, 2008 | Canon PowerShot SD750 / IXUS 75 Digital...
56 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: