Question about Audio Players & Recorders

1 Answer


How you going
im after some stats about the SHARP OPTONICA SM-1515 STEREO AMPLIFIERi cant seem to locate any info about it just wondering what its out put is??

Posted by tez_n_katie on


1 Answer

Pravin Gupta

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert who has answered 200 questions.

  • Expert
  • 275 Answers

15+15Watts per channel PMPO. Optonica is a Brand under which SHARP was Marketed in India.

Posted on Nov 01, 2007

  • dynax9pro Mar 15, 2011

    I had one of these amps. The manual clearly stated 33 33 watts per channel 8 ohm 20-20000 hz. At 1000 hz, the power was 40 40 watts.

  • dynax9pro Mar 15, 2011

    I forgot! Mine was also branded Optonica but it was bought in France (second hand).



Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I need to repair the sharp optonica rp-104 turntable cartridge has information about this table/cartridge. Optonica was a division of SHARP electronics and made some good products back in the day.

Jun 01, 2014 | Audio Players & Recorders

1 Answer

Im trying to wire my radio but i cant find a diagram what color is the hot wire and what colors are the speaker wires

Hi, use the white (orange stripe) accessory wire to power the radio. The red (black stripe) wire is the hot lead used to maintain clock and preset stations for the head unit. The complete factory harness color code is below. Please let me know if you have any questions and thanks for using FixYa.

2006 Mitsubishi Raider Car Audio Wiring Schematic
Car Radio Battery Constant 12v+ Wire: Red/Black
Car Radio Accessory Switched 12v+ Wire: White/Orange and White (This vehicle uses the can data network for accessory turn on.)
Car Radio Ground Wire: Black
Car Radio Illumination Wire: N/A
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: White/Orange and White (This vehicle uses the can data network for amplifier turn on.)
Car Stereo Amplifier Location: Amplifier is located in the passenger kick panel.
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): N/A
Left Front Speaker Negative Wire (-): N/A
Right Front Speaker Positive Wire (+):
Right Front Speaker Negative Wire (-):
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Dark Green/Dark Blue
Left Rear Speaker Negative Wire (-): Dark Green/Orange
Right Rear Speaker Positive Wire (+): Gray/Dark Blue
Right Rear Speaker Negative Wire (-): Gray/Dark Blue

Jan 30, 2011 | 2006 Mitsubishi Raider

2 Answers

97 chevy cavalier keeps blowing f/p-inj fuse. take to sharp a left turn and blam fuse gone... i dont see any peeled wires... but maybe im looking in the wrong place...what am i should i be looking for?


the problem sounds like either the fuel relay, or wire4s coming from the fuel pump to the fuse box.

the relay is most probable as when you turn the electro magnet inside may sway from side to side if faulty. You will have to locate the position of the fuel pump and trace the wires up to the fuse box if the relay is not at fault.

Hope this helps if you need more info get back to me



Jan 01, 2011 | 1997 Chevrolet Cavalier

1 Answer

Im installing a new stereo for my 1995 chrysler lhs. the stereo works, but why cant i get any sound?

It sounds like you have the "Infinity System". The accessory/antenna wire has to be hooked up to the power wire for the factory installed amplifier (should be located under the passenger's seat). Locate the wire from the original harness and hook it to the amp wire. I hope that helps. Please rate my assistance and leave a testimonial.

Dec 31, 2010 | 1995 Chrysler LHS

2 Answers

My sharp Stereo is stuck in '' protect'' mode

Protect mode is not something that a reset will fix. Basically it indicates that there is a problem with the final output stage of the amplifier. Normally this indicates that the output transistors are defective. In most boomboxes, the amplifier is a single IC. If you can post the model number, I can provide you with the required part and cost.


Mar 25, 2009 | Sharp Audio Players & Recorders

4 Answers

Users gude

I couldn't find anything on this optonica stereo company, and do you need to know how many watts it really is? Why don't you just plug it in and see how LOUD IT GETS!!!!

Dec 23, 2007 | StorCase 2 Bays Data Silo DS320 Storage...

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

3,020 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio Players & Recorders Experts


Level 3 Expert

13434 Answers


Level 3 Expert

5700 Answers

The Knight
The Knight

Level 3 Expert

76287 Answers

Are you an Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides