An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has answered 20 questions.
Re: help me for my problem?
If you have your PC suit please backup your data and "hard reset it By holding the Green Key, No.3 key and the * key simontaniously while booting(ie. just after switching on the phone and press all the three keys alltogather for more than 1 minute). It Will start formating to the factory reset.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I am having this same error message appear on my phone but this is not the camera its the messages on mine, i can't send or recieve any messages. Suggestions have been made to me that i do a master reset on my phone so you could always try the same thing. Everything will be wiped from the phone so make sure to back up files you want to keep.
if you are getting the preview in the camera then there is no problme with the strip ... if you are getting the preview error means then the camera strip is surely gone ... you must take the cell to the service technician and get replaced with the new strip ... as this the damageable service it is better to take to technician ... "minor mistakes makes you pay more" .. so just visit the technician ...
any further doubts reply me i am always here to assist you ... thank you bye ..
HI. 1ST U OPEN THE BACK COVER AND REMOVE THE BATTRY > NOW OPEN THE SCREW > PULL THE BACK COVER VERY CAREFULLY PULL UR MOBILE PCB VERY CAREFULLY AND REMOVE THE STRIP CONNECTOR SAME PROCEDURE FOR FRONT SIDE WHEN BOTH SIDES R OPEN THEN CLOSE SLID AND PULL THE STRIP FROM MOBILE'S SLIDE. THEN NEW STRIP ENTER THE SLID AND FLOWS THE SAME PROCEDURE IN REVERS CONDITION. NOTE -(WHEN U PULLED THE STRIP THEN MIND IT WHICH SIDE IS DISPLAY SIDE OR WHICH SIDE IS PCB SIDE.