Headset wont turn on but i can still talk to my friends by holding the power button

take the battery out and put it back,plug in to a good outlet and hold on the power button,if nothing,your power adapter is bad

When the afterglow headset flashes from red to blue, it is in pairing state, youve held the power too long after power-on. Shut it off again and turn it back on and dont hold the power button untill it flashes red to blue. The directions provoded with it aare quite easy to follow. Took me 30 seconds to set mine up

The Turbo Fire 2 Wireless is known to cause some incompatibility with headsets.

The first step would be to make sure both your controller and headset are both properly plugged in.

If your headset normally sends normal game sounds to your headset, it will not work with the controller. The sounds are the things you would hear coming out of your TV.

If your headset is incompatible, you can get an OEM or 3rd party Xbox Live headset that only receives voice communication.

try doing a system reset press the call control button and the volume mute button at the same time for 5 seconds. when the talk indicator light blinks release both buttons. press the call control button again and the talk indicator light will blink again briefly headset is back to normal then unplug the charger from the charging jack for 5 seconds and plug back in headset is reset. if that doesnt work then replace the battery in headset.

Check to make sure that your talkback cable is plugged in tightly. Try unplugging it and then plugging it back in. If you're still having trouble, just contact them at [email protected] and they'll take care of you!

Hi,
Turn your H350 on by pressing and holding the black "Talk" button on the side of your headset. Hold it until the blue status starts to flash. To turn the H350 off, simply hold the talk button until the headset turns off.

Pair your headset with your cell phone by entering into your cell phone's bluetooth menu--Menu > Settings > Connection > Bluetooth Link > Setup (see Resources below).

Put your Motorola H350 into pairing mode by holding the "Talk" with the device turned off. Hold the button until the status light on the side of your headset begins to flash, and turns back into a solid blue.

Back in your phone's bluetooth menu, choose the option to "Search/Discover" bluetooth devices. And when your phone recognizes your H350, select the headset and enter "0000" as the passcode.


Thank You

you must make sure your headset is in pairing mode.

simply turn the headset off and wait a few seconds

now, hold down the power button
the device will turn on but continue to hold the button. When the light turns solid or begins to flash a different sequence (typically 15 sec will do it)
now your device is in pairing mode and can be found by any device in the area that sports the bluetooth hardware.
the default code is 0000

GOOD LUCK AND PLEASE RATE THIS POST!! :D

Try holding down the top on/off button and the home button at the same time. Continue to hold down and within 30 seconds or so it should come back on. hopefully. good luck

Have you tried unplugging the power for a few seconds and plugging it back in?

Try this to get the oven door open. Turn off the power, take a coat hanger and bent at 90 degree angle about 2 inches long. Turn the wire side ways along the top of the door, 2 inches to the right of center, turn your wire so the bent piece is down. Now pull out on the door and move the wire to the left. This should unlock your door so you can get to dinner. What may have happened is that the broil got above 500 degrees at the oven sensor and locked the door for safety. That does happen