When i turn on the tv it takes about 3-4 minutes till i get a picture, then it blinks intermittantly. It has been getting worse.
Sounds like a bad picture tube. Picture and bright settings cranked up for a good pic? Test/rejuv with a crt tester and/or look at the Ik signal on the crt board. A good tube has 3 small pulses during blanking. The crt cathodes are checked with these pulses, pulses too low and the jungle IC will blank the drive. If the picture fades in and out I would check the filament ckt but that doesn't support the "blinks"
231 views
Usually answered in minutes!
×