if your question is that my Honda generator wont idle up when I connect a load (tool) and it stalls then . first see if unit will run on constant setting (switch on front) if nothing or still barely runs or stalls , then your problem is carb or fuel filter (inside tank) one or both is most likely dirty and needs replaced/cleaned

Oct 15, 2016 | Honda EU2000i Companion Inverter Generator...

1 Answer

How tob fix generator after i put too much oil in generator started for 10 secs then puff of smoke and stopped and pull cord wont move ?

Try taking out your spark plug and see if it needs cleaned or replaced

Mar 05, 2016 | Yamaha Ef600 Generator/inverter...

1 Answer

Generator overload light is on and ready light blinks at intrevals of 4 times

Check all the fuses. Sounds like the inverter section has gone south

May 23, 2014 | Generac 5793R iX2000 iX Series 2000 Watt...

1 Answer

When the load goes up so will the voltage

no it wont, is an inverter unit, voltage is regulated.

Nov 03, 2013 | Honeywell Hw2000i Inverter Generator 125cc...

1 Answer

Took my ev6010 generator out and put it back in but hooked up the starter motor to the ground not to the positive and now it wont start. I also changed the oil and coolant.

On the ev6010 Honda generator the posive starter wire is black and was accidently hooked up to the chassis ground wire. Then the start button was pushed and nothing happened. I corrected the wire hookup to the positive side but will not start still

Aug 28, 2013 | Honda Ev4010 Ev6010 Rv Generator Inverter...

1 Answer

Honda e2000i generator no spark

if there is no spark in the plug as you are saying for that matter check the current coil and the inverter section for the loss of current if you have already changed the sparkplug if not do change

Jun 30, 2012 | Honda 3000 Watt Portable Generator

1 Answer

Generac ix 2000 does not start. checked spark plug and it is good. oil good.

what a **** generator, worked for 100 hours and now wont start anymore.
did all the checks and replacing of spark plug and oil etc, simply wont start, ****, ****, ****..... service is horrible too. they just give you the runaround.

Apr 02, 2012 | Generac Power Systems Generac 5793 Ix 2000...

2 Answers

2 generators 1000 watts invertors

NO! DO NOT ATTEMPT THIS. The problem is that you cannot maintain the phase relationship between them. Both of the generators must turn at precisely the same speed and precisely together - which is virtually impossible without connecting the two generators together on a common shaft, which would be impractical to the point of ridiculous.

Apr 29, 2010 | Coleman Powermate Premium Plus 6250W...

1 Answer

Yamaha ef2400 inverter does not start.

it is possible the batteries are dead or needs to be charged

May 28, 2009 | RTO New Yamaha Inverter Ef2400is / Yamaha...

Not finding what you are looking for?

View Most Popular

EU6500iS Inverter Generator

Electrical Supplies

HONDA EV4010 GENERATOR WONT RUN UNLESS i PLUG THE VENT HOSE JUST ABOVE THE FUEL INLET ON THE CARB THEN IT WILL START AND RUN FOR A FEW MINUTES

Honda Ev4010 Ev6010 Rv Generator Inverter Muffler Exhaust Spark Arrestor Kit

Open Questions:

0 Answers

Honda EU65 generator fault codes E10 and E20 someone must know what causes this...please!

Jan 24, 2014 | Honda EU6500iS Inverter Generator

0 Answers

My Eu6500is Inverter generator has an error code of E-10 and E-20. It will start, but then shuts off within 5 seconds. It won't stay running. Does anyone know what these error codes mean?

Sep 06, 2013 | Honda EU6500iS Inverter Generator

0 Answers

my honda EU6500is power generator has fault codes E03, E10, and E20 and shuts off. Do you know what these codes means ?

Oct 19, 2012 | Honda EU6500iS Inverter Generator

Ask a Question

Usually answered in minutes!

Are you a Honda Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Have a manual for Honda EU6500iS Inverter Generator? Or just drag it here!

Inverter wont let generator start - Honda EU6500iS Inverter Generator

Add Your Answer

Attachments: Added items

Related Questions:

HONDA EV4010 GENERATOR WONT RUN UNLESS i PLUG THE VENT HOSE JUST ABOVE THE FUEL INLET ON THE CARB THEN IT WILL START AND RUN FOR A FEW MINUTES

I have a deep eu2000i inverter, the problem is to remove the carburetor throttle, it takes some kind of setting as to start the engine low speed, and connect a tool fails ....

How tob fix generator after i put too much oil in generator started for 10 secs then puff of smoke and stopped and pull cord wont move ?

Generator overload light is on and ready light blinks at intrevals of 4 times

When the load goes up so will the voltage

Took my ev6010 generator out and put it back in but hooked up the starter motor to the ground not to the positive and now it wont start. I also changed the oil and coolant.

Honda e2000i generator no spark

Generac ix 2000 does not start. checked spark plug and it is good. oil good.

2 generators 1000 watts invertors

Yamaha ef2400 inverter does not start.

Not finding what you are looking for?

EU6500iS Inverter Generator

HONDA EV4010 GENERATOR WONT RUN UNLESS i PLUG THE VENT HOSE JUST ABOVE THE FUEL INLET ON THE CARB THEN IT WILL START AND RUN FOR A FEW MINUTES

Open Questions:

Honda EU65 generator fault codes E10 and E20 someone must know what causes this...please!

My Eu6500is Inverter generator has an error code of E-10 and E-20. It will start, but then shuts off within 5 seconds. It won't stay running. Does anyone know what these error codes mean?

my honda EU6500is power generator has fault codes E03, E10, and E20 and shuts off. Do you know what these codes means ?

Related Topics:

Ask a Question

Top Honda Electrical Supplies Experts

Sheldon Dedek

Mike

Marvin

Are you a Honda Electrical Supply Expert? Answer questions, earn points and help others

Manuals & User Guides

Inverter wont let generator start - Honda EU6500iS Inverter Generator

Add Your Answer

Attachments: Added items

Related Questions:

HONDA EV4010 GENERATOR WONT RUN UNLESS i PLUG THE VENT HOSE JUST ABOVE THE FUEL INLET ON THE CARB THEN IT WILL START AND RUN FOR A FEW MINUTES

I have a deep eu2000i inverter, the problem is to remove the carburetor throttle, it takes some kind of setting as to start the engine low speed, and connect a tool fails ....

How tob fix generator after i put too much oil in generator started for 10 secs then puff of smoke and stopped and pull cord wont move ?

Generator overload light is on and ready light blinks at intrevals of 4 times

When the load goes up so will the voltage

Took my ev6010 generator out and put it back in but hooked up the starter motor to the ground not to the positive and now it wont start. I also changed the oil and coolant.

Honda e2000i generator no spark

Generac ix 2000 does not start. checked spark plug and it is good. oil good.

2 generators 1000 watts invertors

Yamaha ef2400 inverter does not start.

Not finding what you are looking for?

EU6500iS Inverter Generator

HONDA EV4010 GENERATOR WONT RUN UNLESS i PLUG THE VENT HOSE JUST ABOVE THE FUEL INLET ON THE CARB THEN IT WILL START AND RUN FOR A FEW MINUTES

Open Questions:

Honda EU65 generator fault codes E10 and E20 someone must know what causes this...please!

My Eu6500is Inverter generator has an error code of E-10 and E-20. It will start, but then shuts off within 5 seconds. It won't stay running. Does anyone know what these error codes mean?

my honda EU6500is power generator has fault codes E03, E10, and E20 and shuts off. Do you know what these codes means ?

Related Topics:

Ask a Question

Popular Questions

Honda EU3000IS Generator Surging / Pulsing Problem

Honda EU3000is generator will not start with electric starter.

Need a battery for honda eu3000is

Gas in the oil on my honda generator

Honda EU3000is Generator is running poorly.

Top Honda Electrical Supplies Experts

Sheldon Dedek

Mike

Marvin

Are you a Honda Electrical Supply Expert? Answer questions, earn points and help others

Manuals & User Guides