Don't have instructions for a scorsche loc2sl how doi do it

Kinh can Sai Gon tu tin la don vi cung cap cac san pham kinh can mong, kinh can doi mau, kinh da trong, ... tot nhat voi gia thanh hop ly, tu van tan tinh chuyen nghiep. Tham khao tai: https://kinhcansg.com/bang-gia-kinh-sieu-mong.html

you can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete

I assume you want to retain the factory stereo and add some subs to it. The answer is yes you can. Simply tie the loc into the speaker leads.

run wires to your installed speakers in rear an hook up to amp

SCOSCHE LOC2SL Line-Out Converter with Bass Control https://www.amazon.com/dp/B00LIAHSM4/ref=cm_sw_r_other_awd_g5Zbxb8HQKEQD
Easy as Pie.

Wire it in a parallel instead of a series circuit

google

If you don't remember the password to your phone, the ONLY way to get back into your phone is by doing a hard reset. This goes for all phones. Unfortunately, this erases all data on your phone.

-ex Sprint rep

if you have a digital volt meter check powers at radio to see if your getting a good ground ..

take the black test lead of the meter put it on the ground were you mounted ground wire. then take the positve red test lead and the touch the red wire on harness from radio to see if there is 12 volts

and the do the same for the yellow wire constant power must have 12 volts all so if you get nothing either its a bad ground or fuse is blow then check fuses if everything is good and no fuses or blow then the radio is bad ....