Hookup I need a instruction manual for hook up

the owner manual for the player should have instructions and a diagram but:

Quick hookup is from selected output on player to same INPUT on rear of set-----select that input on the tv with the remote and should work.

Read the owner manual which should have hookup instructions for this or Google the model number of set or player for "manual" to try to locate owner manual for either or both.

I presume you followed the instructions in the TV manual during hookup and did not hook up with the units powered up and did select the correct input with the remote?

If you have another unit that uses HDMI try a direct hookup with it to see if the HDMI input is working.

HDMI units do not like being hooked up when units involved are powered up and on--seen more than a few where this was the problem and it is worth a try if the Owner Manual does not help you.

Great day Barry!
You need a 15-pin VGA connector to hookup your laptop to your RCA L32HD31 through the VGA ports.Please see attached image.

Here is its Manual instruction ,it will tell you how to hook up d-link http://static.highspeedbackbone.net/pdf/D-Link-DIR-615-Manual.pdf

here's a link to sony's website:

http://www.us.playstation.com/support/manuals/ps3

It seem that you maybe mistype the model number , take a look there http://www.tacp.toshiba.com/televisions/lcd/product.asp?model=32av50u this tv seems to fit yours , if not look at the other one and go in resources , there you can download the manual for your television , i own a toshiba lcd too and its pretty easy to plug i just plug it behind , use to remote input buttom and that it , just make sure you plugged the satellite dish cable at the good place behind your satellite receiver maybe it could be the problem too .

download everything from www.konicaminolta.eu/support

drivers, manuals etc.

Hi joe, if you're question refers to ECS 945GCT-M motherboard, than goto page 12 in the manual. You'll see this
Please read all of pg.12.
It's my guess you bought this board from powerspec. For now forget the two red wires & just hook up the case's wires for all LED's & on/off. Everything should be just fine.

Good Luck!
Mike