AEG Lavamat 88840 Front Load Washer Logo

Related Topics:

Anonymous Posted on Jun 10, 2009

AEG lavamat 6955 sensorlogic, was showing F2,nowF3

AEG lavamat 6955 sensorlogic washing m/c, was showing F2, cleaned out pump,spin cycle continued OK but now F3+1000+900+spin lights flashing. Any ideas?''

  • 2 more comments 
  • Anonymous Mar 20, 2014

    Originally there was the c9 error brushs were down to 1 cm these have been changed / error code was erased and then when it came to the spin cycle the pump continued to try to pump and but no spin the result was a c9 error again. Any tips

  • Anonymous Mar 24, 2014

    Error 10

  • Anonymous Mar 24, 2014

    No water intake on start-up.
    Error code 10

  • Anonymous Mar 24, 2014

    No water intake on start-up

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

  • Contributor 1 Answer
  • Posted on Jun 12, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Joined: Jun 10, 2009
Answers
1
Questions
1
Helped
1821
Points
2

Waited half hour; on start up F3 had cleared..pump overheat? Suspect sticky pump bearing..new pump.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Have a AEG Lavamat Turbo wash dryer that stalls mid cycle full of water and code 21

E21 means a blockage in the drain pump.
I would check the impeller spins freely. A coin from a pocket can cause that error as it gets stuck in the impeller.
1helpful
1answer

Hi, i have an AEG Lavamat 1100. Although the machine runs through the spin cycle, and shows the wash cycle as being finished, when i open the door there is still water in the bottom of the machine and the...

Hi bwileman435,

It may not be draining well, because it is dirty, did you clean the Drain Pump filter?

Please follow my below Tip on how to do it:

ACCESS, DRAIN & CLEAN THE DRAIN PUMP FILTER

Kind Regards d")

* If this solution helped you, please rate it
0helpful
1answer

AEG Lavamat 76400 during spin cycle blows a fuse

its not the heat element its the water pump i would say it has gone to ground try disconnecting the water pump if the fuse does not trip then replace the water pump
0helpful
1answer

Water not pumping out and therefore no spinning occurs

Hi, just solved the same problem with our aeg lavamat w 1020. Try checking the filter tray (or port) at the bottom left-hand corner of your machine. This was our problem and as soon as the blockage was removed the machine could be pumped out. It appears to be running OK now.
0helpful
3answers

Please help

your machine is draining too slowly. When it initiates a drain cycle, the water level switch is sensing the water level is still too high after 60 seconds so the computer1.gif stops and generates this fault code.

Here are the things to check;

* Check the drain hose and make sure it is not plugged or inked.
* Check Wire Harness connectors to the Drain Pump, Pressure Switch, and Central Control Unit (CCU)
* Check/Clean Drain Pump Filter of foreign objects
* Check for Drain Pump Failure
* Check the Inlet Valve for proper shut off
* Check the Pressure switch for proper operation
1helpful
1answer

AEG lavamat 6955 showing F9 on display panel

unplong machine and restart it .eamonn eire thank you
1helpful
1answer

AEG Lavamat W1450 2 years old,

possibly wire come loose or try disconnecting heater element and repeat spin cycle.if runs well then, replace heater.
0helpful
1answer
0helpful
1answer

Lavamat 6955 sensorlogic - carries on filling until water overflows from soap tray

fault f1 is slow or no cold fill. this fault code with overfill points to: air chamber blocked with sludge hose from air chamber to pressure stat blocked or split pressure stat faulty of these the first is the most likely
Not finding what you are looking for?

1,831 views

Ask a Question

Usually answered in minutes!

Top AEG Washing Machines Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

Are you an AEG Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...