Washer stops after aggatating and wont drain

is it under aggatator?

Does it fill and not agitate? If so, you will need to replace the lid switch.

Thanks for choosing FixYa and welcome. You need to check the motor drive. It controls the spinning and the agitation.

Might be something in the pump. This video shows how to access the innards:


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

its suppose to start with lid down,the draining may be a faulty water level switch so this needs replaced.

We had the same problem and it was really easy to fix. On the dial for the load size, turn it all the way to the right to "reset" and then check to see if it resolves the problem. It did with our washer same model and problem. Best wishes.... Doug

If the cycle does not stop draining that is usually because of a faulty membrane switch that controls the water level in your appliance.
The faulty sensor cause the machine to think that there is still water inside, even when water has drained completely.

Sounds like motor starter capacitor and/or motor fried.

check the water pressure switch and the hose connected to it for an obstruction
if the machine is aggatating it can not allow water to come into the machine cause it thinks it is at the water height that the pressure switch is set at or the tube was some gunk in it that is making the switch stay closed

remove the hose from the pressure switch it is clear and blow through it if it blows freely then the pressure switch is bad and replace it
if not blowing free blow hard to remove obstruction

see if the srew has loosend up from the transmission shaft