Teac cd receiver sl d80

Laser assembly apparently is inoperative. Time to replace unit since repair is not cost effective.

Download the user manual to this sert from net. It will have all details.

The Nikon D80's shutter can be released via handheld "IR" or infrared remote. You can buy them online or in most camera shops. The Nikon branded one will cost the most, but really doesn't perform a whole lot better than the $5 third party versions. The nice thing about IR remotes is that only a transmitter is needed. There's a built in IR receiver on the front of the camera body, and as long as it is not obstructed - or too far from the transmitter, it will work fine.

The SB600 will fire if setup to work correctly when the shutter is released "normally" - triggering with a IR remote will not affect the SB600 flash whether mounted on the camera or if in "commander mode". The D80 manual has details on pg 38 to operate in both the instant and time delayed IR operation modes and should be consulted as Nikon does not allow copy and paste from the manual - and they make use of graphics for button functions.

When distances are too great for the IR remote, you'll need to go the route of an RF or radio frequency remote instead. Many of these will work at distance up to and even beyond 100 yards. They consist of a transmitter and receiver. The receiver can be mounted on the hot shoe of the camera or tethered via cable to the camera body. This is not the question you asked about, so I won't go into further detail - but only mention it as another way of doing the same thing from greater distances or when you can not be in front of the camera to access the IR receiver on the D80 body.

If this was helpful, please rate it as such. Thanks and good luck!

Sadly there is nothing you can fix on these as a layman. You might try new CD's and clean the old ones with windex.

Here's the link to download your User Manual pdf file, please follow the graphical instructions below so that you'd not make any mistakes. The file has three parts winzip file, you'll need to download all the three parts otherwise you can't open the Pdf. Open this link and look at the pictures to download
http://www.eserviceinfo.com/download.php?fileid=55834

Good luck. Thanks for Choosing FixYa.

use cleaner cd

Set the release mode to one of the two remote modes. Quick-response takes a shot immediately, Delayed-remote waits two seconds, giving you an opportunity to hide the remote control behind your back.

Try the reset button.
it's a tiny recessed button under the cd cover on the right side

ON THE SIDE OF THE RADIO
Leave the slider in the"OFF" position. Press and HOLD the "Clock Adjust" button.

The light on the front of the radio should be blinking while you hold the button down.

While holding the button down......
To adjust hours: Press the ">>" button on the front of the radio
To adjust the minutes: Press the "<<" button on the front of the radio.

That is all there is too it.

Probably you want to convert it to 220 volt. Simple, go to mechanic who will take out Transformer and easily convert it to 220, I got it done myself as well, AM/FM will work properly being analogue tuning.