Question about Brother DCP-7040 Laser Printer
Posted by Anonymous on
Routine maintenance and keeping full ink tanks will prevent this problem, however if you have the problem you can resolve it by doing the following:
1. Clean your print head using denatured alcohol solvent which can be purchased from most hardware stores. If unavailable, use 91% Alcohol (isopropyl alcohol (first aid antiseptic) which is available for less than a dollar at most Walmart pharmacy departments.
*Warning: You may want to use a pair of latex exam gloves as this is a messy process and can stain your fingers.
Time necessary 45-50 minutes
Isopropyl Alcohol or denatured alcohol
sink, bowls and or basin
can of compressed air
very small screw driver
tablespoon or baby bulb type syringe
1. Lift print head from printer. It pulls out easily because it is held in with the same down lever that holds the cartridge in place.
2. Put two layers of paper towels in the bottom of a dish to protect sensitive sprayer heads.
3.Put enough solvent in dish to cover the screens on which the cartridges sit when in use.
4. Take the two small screws out that hold the white ceramic piece
5. Gently, pry the ceramic piece back and away , to reveal the underside (No need to pull away the glued points on the sides.)
6. Gently, move head up and down to slosh solvent around it the best as you can. Use a table spoon or syringe to pour solvent over all orifices in the print head, turning it upside down and then back a few times.
7. Use canned air with a plastic straw to blow into and through all orifices, alternately sloshing/swishing and pouring solvent over head (be careful not to touch any of the holes, screens, or sprayer heads with anything)
8. Empty dirty solvent from bowl and replace with paper towels and clean solvent. Soak for approx 10 minutes. Rinse again with clean solvent poured directly on all parts, letting solvent overrun and fall into dish or basin.
9. Gently shake the solvent off the head, take it outside and spray with compressed air into all orifices to clear out and help evaporate any remaining solvent. Let sit on a clean paper towel for approx 20 minutes. (There may be a little ink bleeding out of the head, but once it dries completely it does not present any problems.
10. Reinstall head, cartridges and it will print like a new printer.
SUGGESTION: For many years of problem free printing, keep a double set of ink cartridges, one set full at all times. Whenever a cartridge runs out of ink, replace it IMMEDIATELY, with a new one or a refilled one. This gives the print head no chance to dry out and create clogged heads. Routine maintenance of cleaning the heads every 24 months does wonders for keeping your printer in new condition.
Hope this helps. .
Posted on Feb 08, 2010
Tips for a great answer:
Sep 11, 2014 | Brother Office Equipment & Supplies
Apr 09, 2012 | Brother DCP-7020 All-In-One Laser Printer
Jul 19, 2011 | Office Equipment & Supplies
Jan 25, 2011 | Brother DCP 115C All-In-One InkJet Printer
Jul 13, 2010 | Brother MFC 210C All-In-One InkJet Printer
May 16, 2010 | Brother DCP 165C Compact Color Inkjet...
Sep 03, 2009 | Brother DCP-7020 All-In-One Laser Printer
Aug 05, 2009 | Brother DCP-350C InkJet Printer
Dec 31, 2008 | Brother DCP-7020 All-In-One Laser Printer
55 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: