Only upper half of letters showing - IBM Wheelwriter 6 Typewriter

Oh please don't tell us what router, remote or anything else that would actually help find a solution to your problem. We'll just sit here and ignore your question.

go to a jeweller

If that is the only problem replace the printwh
DickyO

Try typing on a miltipart form. If the carbons are good the problem is the ribbon. Not lifting, folded,
very old or the correction tape is in the way. If the copies are the same then be sure the platen is seated fully in the side frames.

DickyO

Make sure you are entering the letters in upper-case when entering the password to connect to this router. The iPad always shows letters on the keyboard in upper-case, but they may be entered in lower-case and it will not connect.

Your ink cartridge has about 9 very small nozzles that spray ink to complete a letter the upper nozzles complete the upper half and the lower half is done by the lower nozzles. The lower nozzles are stopped or clogged up by dried up ink or the control resisters in the firing circuit are burned out. some times you can unclog the nozzles by soaking the lower part of the cartridge in hot water for a half hour and drying it well ,replace it in the carrier and try it again. However you will lose a lot of ink and it may be more prudent to replace the cartridge.

May just need motion adjusted. It's really important to know the model number. Do you have it?

If this is a wheelwriter push down firmly on both end of the platen they do pop out. DickyO

i might be wrong on this one, but all motorola's are mostly the same on texting. Soto get a capital letter in text just press the 0 before the letter

Possibly you have a bad Daisywheel or printhammer assy.