My mom's Pride Go Go is charged but beeps once and shuts off

BEEP CODE CONDITION SOLUTION
2 Battery voltage is too low to operate Charge the batteries fully until charger and
the scooter. any meters indicate completion.
3 Battery voltage is too high to operate Contact your authorized Pride Provider for
the scooter. assistance.
5 Solenoid brake trip. The manual freewheel Remove the key, then push the manual
lever may be in the freewheel position. freewheel lever to the drive position and
restart the scooter.
6 Throttle trip. The throttle control lever Release the throttle control lever completely,
may have been depressed while inserting then reinsert the key.
the key.
7 Throttle trip. Throttle potentiometer Contact your authorized Pride Provider for
fault or speed potentiometer fault. assistance.
8 The motor is disconnected. Contact your authorized Pride Provider for
assistance.
9 Possible controller trip. You may be Shut down your scooter for a minimum of
attempting to install the battery pack while several minutes to allow the controller to
the key is inserted or the motor controller cool. Or, try reinserting the key into the key
may be in overheat protective mode. switch.
What you may be doing is mis-counting the beeps and it may be 9 beeps or its 8 and you have a bad connection between the motor and the switch? Good luck!

This is due to the controller shutting down. Make the brake leverin the on position

The PGDT controller may have been programmed to go into sleep mode. If so, if the chair isn't used for up to 10 minutes, the chair will go into sleep mode - then beep every once in a while to remind you it is sleeping.
Go ahead and wake it up and then shut it off. It won't mind.

Have you had a look at the condition of the thermal paste?

biqiu Check out my tip on getting your chair out of lockout or sleep mode this should help with your problem Good Luck

turn it on then push the joystick forward till it beeps then pull it backward till it beeps then it will unlock. chair is in lockout mode

I've never seen an oil pressure sensor that costs $750...Likely something else was done to justify that cost. If the light has not come on since the repair, I'd assume that problem has been corrected. If not, have the thing checked out again. If they charged you to repair it, then it should be fixed or, it's their problem!!! You should not be afraid to drive your vehicle. It's a machine, therefore it can and will break sometimes as do all cars. But being afraid to use it is not a solution.

sounds like a dead battery to me . Is it getting a charge? when you turn it on do the lights in the joystick light up? check the Pride Mobilty web site, it has tons of useful info

anti theft. while the lights are flashing, hit the horn button twice.

Call pride. That is under warranty. The will replace it.