Xerox docucolor 12 does not acknowledge network controller

NVM CHANGE
752-008 = 2
702-031 = 1
702-032 = 30
702-037 = 0
702-038 = 0

DEVELOPERS:black 5R616 ; yellow 5R 619 ;magenta 5R 618;cyan 5R617
TONER : magenta 6R1051 ; cyan 6R1050 ;yellow 6R1052

check ur fiery card that connect to copier
remove card clean any dust at the pins / slot lines then try

hi
hi ok

no. you need some type of rip for it. the dc12 has no internal memory or network capability on its own

Pretty vague question.
The Doc 12 probably has a Fiery Network controller, while the 7132 has a Fuji/Xerox controller.
The Doc 12 would have limited scanning capabilities while the 7132 can, depending on the config ordered, scan to E-mail, SMB, FTP, Scan to PC, and scan to a mailbox on the Xerox itself. If you have an embedded fax in the configuration, you can set it to catch incoming faxes and forward to e-mail, or a SMB or FTP folder on your PC or server.
The 7132 is rated at 8 pages a minute in color mode, and 30 pages a minute b&w.
The Doc 12 has been around since 2002, the 7132 is about 3 years old and has been replaced by the 7232.

in fiery do this following < clear server>

This product is not supported in the Microsoft Windows Vista Operating System.


but here is a link for Vista. Choose either Vista x64 or Vista and see if it becomes available:

http://www.support.xerox.com/go/results.asp?Xtype=download&prodID=DC12LP&Xlang=en_us&Xcntry=USA&prodName=DocuColor%2012%20Printer

You can order them from this site..

https://www.partsdrop.com/store/

Hi, there is no way to change language on Touch screen without calling Service. Best regards.