Robot coupe keeps stopping

Wiring diagrams are in the back of the manuals after the parts lists.

https://www.partstown.com/robot-coupe/blixer-3b/parts#id=mdptabmanuals

..

To add the pulse button to your Robot Coupe R101, you will need to purchase the R101 Plus switch and front panel. The replacement is relatively simple and can be done by following these steps:

1. Turn off and unplug the Robot Coupe R101.
2. Remove the screws that hold the top cover in place and lift off the cover.
3. Locate the control panel on the front of the machine and remove the screws that hold it in place.
4. Carefully remove the control panel and disconnect the wires from the old switch.
5. Install the new R101 Plus switch onto the control panel and connect the wires.
6. Replace the control panel onto the front of the machine and secure it in place with the screws.
7. Replace the top cover and secure it in place with the screws.

Once the new switch and front panel are installed, you will have the pulse button on your Robot Coupe R101.

Yes you will need to replace the machine.

You may be able to get it here:

http://www.nisbets.ie/products/AdvancedSearch.asp?keyword=cl30&x=64&y=5&PageSize=50

The part isn't listed but if you ring them they might be able to order it in.

It is overheating, probably because it is being overworked. Some common problems are overloading the bowl, or forcing too much food into the hopper on top. Once it overheats, it will kick out again rather quickly the next time unless the motor has time to cool. If you are shredding cheese, slow down on the amount of cheese forced into the blade. If you are trying to mix heavy dough you are probably overloading the bowl as well. This machine can't handle over a pound of pizza dough without overheating. The reset button is there to keep from burning the motor out. If you continue to reset and force feed the machine, it will burn the motor out. Good luck, hope this helps.

It just a long shaft phillips screwdriver. The screws are located under the foot pads. They just pull out and then there are the four screws.

Robot-Coupe USA.com should be able to sell you anything needed

Cindy,
Send me your e-mail & I will send you back an exploded view of your Robot-Coupe. It will give all the info needed. [email protected]

The clicking noise is an internal circuit breaker or motor protector. These things are not made to be bogged down or overfed. The motor is heating up & tripping the overload, after cooloing it resets. Time to buy a new one or get the motor replaced ($600-$800)

3BX9k4 PLEASE DESCRIBE IN BRIEF WHAT THE PROBLEM IS?