Question about Omega Trane Furnace Draft Inducer Blower 115 Volt Variable Speed Fasco # A190

1 Answer

Trane XE 90 LED code 5 and code 9 (furnace).

I have a Trane XE 90 that was installed in Feb 2001. Yesterday, it stopped producing heat. This morning I checked my breaker box and saw that the furnace breaker had tripped. I reset the breaker and checked the diagnostic codes. The LED flashed 5 times, then flashed 9 times repeatedly. I replaced the Igniter (code 9), but the furnace does not come on and the LED still flashes code 9'', after initially flashing code 5. The blower does come on and runs continuously (I think it is the blower that circulates air thru the ducts. Any suggestions? It still gets cold at night in northern Ohio. Thanks.

Posted by thegunman52 on

Ad

1 Answer

billrichey

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

High limit is open try tapping on it gently

Posted on Aug 10, 2009

Ad

1 Related Answer

Thomas Stewart

  • 582 Answers

SOURCE: I have a Trane Xe-60 furnace about 19 years old.

THIS IS A COMMON PROBLEM WITH THE DOOR SWITCHES, MY FIRST ANSWER WOULD BE REPLACE THE SWITCH SECOND WOULD BE OPEN THE DOOR AND PUSH THE BUTTON IN AND SEE IF THE FURNACE WILL WORK. THIS SWITCH IS JUST A DOOR SAFTEY IF THIS WORKS. I HAVE TAPED A PIECE ON THE INSIDE OF THE DOOR WHERE THE SWITCH WILL HIT THE DOOR ABOUT A 1/4 INCH THICK AND SEE IF THIS WILL GET YOU RUNNING UNTILL YOU CAN GET A SWITCH

Posted on Oct 12, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trane xe 90 burner wont light


Bad igniter? Could be a safety control telling the furnace not to light. Check to see if the furnace has a diagnostic indicator. If so count the flashes and then check the diagnostics list inside the door or in the owners manual. This should narrow the problem down.

May 01, 2014 | Heating & Cooling

1 Answer

My 2002 trane XE 1200 gas &electric unit stopped blowing air


it may be the blower motor not working inside the house check the cap for the motor & the power to the motor

Apr 28, 2014 | Heating & Cooling

2 Answers

Had 16 xi Trane heat pump installed 3 years ago. It ran well for the first couple of years. It began to stop heating and would blow cold air only. Have tried both aux heat and reg. heat to run and neither...


That's a complicated system that needs a qualified technician to service it. Lots of people can install them and they run fine, for a few years. Your indoor unit, operating on 2 heat elements, will feel like its blowing cold air even though its heating, just not so well. And not like you are accustomed to. Each element (5kw)=22.7amps, on average. So 3 elements operating should trip a breaker. Its probably been operating on 2 heat element plus the heat pump. And now you have trouble with the heat pump. If you can't TRUST the guys working on your equipment, try someone else. A second opinion. Normally a 3 or 4 ton unit will have 15kw heat installed, heatpump or not. 5 ton, 20kw. If yours is a 3-4ton, cooling, the 100amp(or normally two 60 amp) breaker should have been installed upon equipment change out. If yours is blowing cold all the time, something is wrong with your heatpump. The electric heat inside operates only when the heatpump can't keep up(real cold outside), the heatpump is in defrost(then it's actually in cooling mode), or if you have the tstat in aux/em. heat. Try a local trane dealer? Of a technician with 15-20 yrs under their belt. A trane dealer should have trane tech support also. BIG HELP!!!

Mar 01, 2017 | Haier Energy Star ESA3183 Air Conditioner

1 Answer

Hi, I have a 1984 Trane Weathertron Heat Pump/Air Conditioner. We had to move the thermostat a couple feet. When we tried to use it, the system would not turn on. We reset the circuit breaker; the power is...


You likely blew the low voltage fuse. Uncertain about the weathertron but it's likely a buss style fuse. I typically cut it out, add 2 spade clips and install a blade style fuse (5amp) . Turn power off first and check blower compartment.

If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Dec 02, 2017 | Heating & Cooling

1 Answer

I have a older model trane we had thnder storms yesterday and the breaker tripped hit the breaker but i get no cold air


check the fuses at the disconect prob blew them they are outside by the unit prob a grey box follow the wires from the condensor

Aug 20, 2010 | Heating & Cooling

3 Answers

I have a Trane xe 70. The Heat is not turning on. The ignitor will glow but NO gas or blower. I turn on the fan and the blower does work but not when HEAT is selected on the t-stat. Also the LED light...


Check to see if you get 24 volts AC at the gas valve from the circuit board when the igniter is glowing. If yes, bad gas valve or blockage in gas train. If no, bad circuit board or broken wire

Feb 07, 2010 | Heating & Cooling

1 Answer

Trane xe 1200, can i use the heat blower with out a working compressor, i need heat not air, thanks


you can switch the thermostat to "emergency heat" which will turn the outdoor section off and the thermostat will control the electric heat elements in the air handler if it has them.

Oct 19, 2009 | Omega Trane Furnace Draft Inducer Blower ...

1 Answer

Heater trane xe 90 working iregular, set to 70 heats up to 64


Possible problemis due to a thermo-couple that has seen better times. If I understand your system correct I would check that.

Jan 13, 2009 | Heating & Cooling

Not finding what you are looking for?
Omega Trane Furnace Draft Inducer Blower 115 Volt Variable Speed Fasco # A190 Logo

2,433 people viewed this question

Ask a Question

Usually answered in minutes!

Top Omega Tools & Hardware - Others Experts

Pieter Vleeshouwers
Pieter Vleeshouwers

Level 3 Expert

2020 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

The Knight
The Knight

Level 3 Expert

76390 Answers

Are you an Omega Tool and Hardware - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...