F07 washing machine stopped during cycle and displays f07

Hi I hope this helps....

F07 - Motor Control Unit (MCU) Error - Disconnect power and unplug unit. Check wire harness connections between drive motor and Motor Control Unit (MCU), and between MCU and the Central Control Unit (CCU). Reconnect power and plug unit in.
Check the MCU by looking for operations of the drive motor, and check drive motor for powered rotations. Replace failed component.

Note: If this failure occurs during high-speed spin, the door will be unlocked after three minutes.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

F07 - Motor Control Unit (MCU) Error - Disconnect power and unplug unit. Check wire harness connections between drive motor and Motor Control Unit (MCU), and between MCU and the Central Control Unit (CCU). Reconnect power and plug unit in.
Check the MCU by looking for operations of the drive motor, and check drive motor for powered rotations. Replace failed component.

Note: If this failure occurs during high-speed spin, the door will be unlocked after three minutes.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

The F07 indicates a Motor Control Unit (MCU) Error.

1. Disconnect mains power and unplug unit.
2. Check wire harness connections between the Drive Motor and the Motor Control Unit (MCU), and between the MCU and the Central Control Unit (CCU)
3. Check the MCU
4. Check the Drive Motor
5. Check the Wire Harness
6. Reconnect power and plug unit in.
7. Check the MCU operation by looking for movement of the drive motor, and check drive motor for fully powered rotation.
8. Replace failed component. Note: If this failure occurs during high-speed spin, the door will be unlocked after three minutes.

Select PAUSE/CANCEL twice to cancel the cycle.
Select DRAIN/SPIN if there is excessive water in the washer.
Re select cycle and select HOLD TO START.

Read this thread about your error. I am sure it relates to your (drain) problem.

Good luck and if you have any more questions, just come back here and leave a comment - I'm happy to help.

F07 - Motor Control Unit (MCU) Error - Disconnect power and unplug unit. Check wire harness connections between drive motor and Motor Control Unit (MCU), and between MCU and the Central Control Unit (CCU). Reconnect power and plug unit in.
Check the MCU by looking for operations of the drive motor, and check drive motor for powered rotations. Replace failed component.

Note: If this failure occurs during high-speed spin, the door will be unlocked after three minutes.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

F07 - Motor Control Unit (MCU) Error - Disconnect power and unplug unit. Check wire harness connections between drive motor and Motor Control Unit (MCU), and between MCU and the Central Control Unit (CCU). Reconnect power and plug unit in.
Check the MCU by looking for operations of the drive motor, and check drive motor for powered rotations. Replace failed component.

Note: If this failure occurs during high-speed spin, the door will be unlocked after three minutes.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

See if you are overfilling you machine or the load is out of balance. Even try running the machine empty

Error code F07 is indicating that the heater relay is stuck for one reason or another.
This could be a board problem, as this where the relay is located.
However, it would be worth checking that the heater is o/k before you do anything else., as this possibly could cause the relay to malfunction.
Plz rate my solution.
Thanks.

washer wf860 showing f07 error. why