Unable to dial out, check voice mail and see call display
We have a Curtis corded TID582. When the phone rings we hear it and the person on the other end. However, when we try to dial out all we get is the dial tone. We have tried a variety of button pushing and nothing works. Also, the screen on the back of the phone is not showing call display. Do you have any solutions?
Re: Unable to dial out, check voice mail and see call...
Hi at the back of the phone you will see a selectable Hi/Lo/Off switch. Slide the (Ringer) switch to High position or Low position to turn the ringer on. Hi for high volume Lo for low volume.
To prevent hearing any ringing of incoming calls slide the (ringer) switch to the off position but when you ready to accept incoming calls again remember to slide the switch back to either Hi or Low setting. Hope this made sense and helped.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The Nortel and any other of PBX come with the voice mail, and you configure the voice mail as a phone ring.... If you can not pick up your phone in 3 time of ring then automatically your phone transfer on Voice mail and there as you setup..........In voice mail it asked which number you want to call and say the details Example: - Dail 1 to Drawing Room Dial 2 for Dinning Hall Dial 3 for Bed Room..
You just configure you voice mail system and solve you problem.
This is just for your phone ringing when it's dialed, not for outside lines ringing on your phone.
From your intercom, dial *7104 (CF No Ans) 500 (if that's your VM extension) # That will flash your FWD/DND light to tell you it's forwarded on No Ans. Now on the intercom, dial *71324 The 713 part tells your phone to forward after xx seconds. 24 is about 4 rings. You can adjust the timing using 6 seconds as a ring cycle.
Your phone can have 3 options, Ring all the time, Switch between Voice and Ring, or Voice all the time.
From your phone(s) press PROG 21 and press the ENTER soft key (3rd key). Now press the SEL (3rd key) until it says VOICE CALL then press ENTER and EXIT. If you set it to this mode, the AUTO ANS button won't work.
If you select TONE, the Auto Answe button will work, making the phone VOICE CALL when lit and ring when not.
If you select VOICE CALL DENY, the AUTO ANS button still won't work and ...you get the pattern.