I need to know how to recharge my 450 amp jump starter

Here are the steps to replace the charger for the Power On Board 450 amp VECO12POB jump starter:

1. Unplug the charger from the electrical outlet and remove it from the jump starter.
2. Locate the charging port on the jump starter and remove the cover.
3. Disconnect the old charger from the charging port by gently pulling it out.
4. Take the new charger and insert it into the charging port until it clicks into place.
5. Replace the charging port cover.
6. Plug the charger into an electrical outlet and charge the jump starter according to the instructions in the user manual.

Note: Be sure to use only the manufacturer-recommended charger for the Power On Board 450 amp VECO12POB jump starter. Using a different charger can damage the jump starter and void the warranty.

chare = charge


https://www.youtube.com/watch?v=0E_TiA6cJqI

UpBright AC Adapter Charger For Vector 450 Amp Jump Start System...

This is a generic charger cord listed by Amazon specifically for the Vector 450 Jump Starter.

Use a voltage meter to see if it has 12-13 volts

After searching the internet for a ph number for Peak power I finally found the web.
http://www.peakauto.com/contact/site.
phone 800-323-5400
If the part department doesn't have the answer ask to be switched to tech support.
They were able to provide me with the part numbers I need for new wall supply cord and an DC adapter for the car.
My jump starter is no longer made...

12volt dc @ 1 amp . Radio shack has em

There is a male 120V plug on it that you connect an extension cord to.

Where can i buy the power cord to recharge my Power on Board 12 volt 450 amp

12 v Dc @ 1 amp...Radio Shack

try this website and keep it as a favorite on you webpage if you have google
they have tens of thousands of free owners manual including for vehicles

http://www.manualnguide.com/