How do I remove the piezzo beeping from my new range. The owners manual describes the procedure but it only turns off some of the beeps. I need to now how to access the piezzo buzzer and dismantle it. I believe the plastic cover snaps or unscrews off to expose the small tin sound board that I can remove and replace the cover.
SOURCE: FRIGIDAIRE GAS RANGE LGLGF388DS
I WOULD TRY UNPLUGGING YOUR APPLIANCE. TURN GAS COCK "OFF" (BY LAW THERE SHOULD BE ONE NO FARTHER THAN 6 FEET FROM YOUR STOVE) PLUG STOVE BACK IN. SEE IF IT MAKES THE SAME NOISES. IF IT DOES, CALL THE GAS COMPANY TO SEE IF YOU HAVE THE PROPER GAS PRESSURE GOING TO THE APPLIANCE. (SOME GAS COMPANY'S STILL WILL CHECK THIS AT NO CHARGE". NEVER TRY TO REPAIR ANY GAS OR ELECTRICAL APPLIANCES YOURSELF. FIND A LISCENSED APPIANCE REPAIR COMPANY IN YOUR AREA (SEE IF THEY ARE LISTED IN THE BBB AND HOW LONG IN BUISNESS) UN FORTUNATELY, ALL THE NEW APPLIANCES WITH ALL THE NEW "BELLS AND WHISTLES" ARE USELESS AND COSTLY TO REPAIR IN MOST CASES. DONT GET RIPPED OFF MAKE SURE THE REPAIR COMPANY IS CERTIFIED TO WORK ON YOUR MAKE AMD MODEL. Joe_Rex (New Member)
SOURCE: IT WON'T STOP BEEPING!
I hate to say it, but the touchpad or computer board needs to be replaced. VERY expensive...goodluck
SOURCE: burners will not turn on and it beeps code f5
the fault codes can be found here: http://www.repairclinic.com/0078.asp#Frigidaire
Mike
SOURCE: I need help with my frigidaire self cleaning confection range it is flashing F1
Hello traden,
Welcome,
You said, What do I do to get my range to stop beeping and flashing F1
Please send me your complete model number including that number at the end of the model number.
pull open the storage drawer and you will find a sticker down low on one side.
Mean while you may try unplugging the range for 5 minutes and that should reset the system if it is only a glitch!
Waiting for your Complete Model number.
Huuum
SOURCE: Starts beeping and F31 ERR flashes
Its a shorted probe connection.
check resistance at room temp if less than 500ohms replace rtd sensor probe.check for shorted sensor probe harnessbtween EOC and probe connector
64 views
Usually answered in minutes!
×