Whenever i turn on my ricoh aficio 2022 this code apear and ask me to contact.......
error code is:
sc542
mach
j8353903020
SC 542 Basically the machine is telling you that the fuser did not reach its target temperature in a specified amount of time. In normal circumstances this code will apear if the thermistor is not maintained or replace periodically or in abnormal circumstance the heat lamp blew. This is a Service Tech reset code. You must go in service mode and then reset the SC/Jam in the service tables.
To prevent this:
1. Never start the machine if your office is far below room temperature. The machine.
2. Maintain the termistor
This is the only information I could find. Read [0272- 0275]
here is the reset procedure:
http://www.fortc.com/2007/06/17/ricoh-cl...
×
I had to replace the fuser kit. Am using a aficio 2020d and was getting the SC 542 error.
There is a fault at your fuser unit (Heater unit).Check thermistors therofuse or thermostat,
I have a Aficio 551/700 and the display reads SC124 anyone have a suggestion on how to re-set this
Thanks
ES...ASD
Erro toner empty , aficio sp1000sf , plesa held
Order a new fuser unit thats the problem
27,702 views
Usually answered in minutes!
It started with change photoconductor error. We changed the photoconductor but the chnge photoconductor error message did not disappear in addition it now display SC542 error message
Lanier 5622- SC 542. Happened on 6 degree morning. Customer had heat turned down. I read on Smarka to reset: CLEAR, 107, STOP (HOLD FOR 3 SECONDS, turn off main power (under panel), then turn back on. Tried this 5 times, no cigar. Customer is CPA, & tax time here. Any help appreciated.-Doug
dear sir / madam,
hi i have problem on my copier model Ricoh aficio 2020 and have error display SC551 can you please advise assist me about this problem.
thank you and hoping for assistant regarding this problem.
Romer
kanka nasıl yapcaz
Lanier 5806E
error SC 542
Hello I have a Ricoh Aficio SP 3410DN, which in the console configuration from Windows shows me the error SC542, and the printer all the LEDs light up me, how I can fix it? because the printer has no display. I would appreciate your help respond to [email protected]
Hello I have a Ricoh Aficio SP 3410DN, which in the console configuration from Windows shows me the error SC542, and the printer all the LEDs light up me, how I can fix it? because the printer has no display. I would appreciate your help respond to [email protected]
×