AR-260 C how to reset start-up code - Sharp AR-C260M All-In-One Printer

Have you tried to replace the toner???? Are you sure the light that is blinking for the toner?????

H5-01. 5 Continuous POUT not-reached error

perform the following procedure to enter the simulation mode.


#-interrupt-c-interrupt-14-ready key

Did you open the left door and clean all the paper out of your fuser and exit area? If you cleared paper and code and get it again either your fuser needs a rebuild or your transfer belt if not moving paper through fast enough. H5-01 means five consecutive attemps to send paper through the fuser have failed.

enter simulation: pound, interrupt, clear, interrupt, then enter 14, press start,press execute on touch screen, press ca until copier restarts, this is a general clear code, if problem returns you will have a heat problem in the fuser.

enter code 14 press copy key

Sharp Fuser
H2-0 Fusing unit temperature error
H4-0 The fusing unit doesn't heat up.
***ALWAYS DISCONNECT POWER WHEN WORKING ON MACHINE***
You have to reset fuser errors with simulation 14. Push P * C * then 14 then Start (the button you use to make copies) and it should reset the code. If not then replace the fuser.
SM 5-1 should turn the lamp on. If lamp blinks on and off it is the thermistor, if it does not it is the lamp, but check the contacts on the lamp/fuser -- they have been known to erode.
Also check thermal fuse, if defective replace.

Try unpluging it and waiting about 15 minutes and the plug it back in or press and hold the on/off button for about ten seconds 'til it completley powers down. That might work. if it doesn't consult your dealer or manuel. Hope this helps!

I don't have that error code specifically but any error code that starts with an H has to do with the fuser section of the machine. It could be the thermistor, rollers, or the heat lamps.

It should be looked at by a Sharp technician to determine the correct problem.

Hi Sorry cant send manual U have to buy like every one else.But here are the codes you require It is service code 24 sub code 04 to reset PM counter and sub code 07 to rest drum sub code 09 to reset print count and sub code 11 to reset developer. Hope this helps