Lionel Trains The Polar Express O Gauge Train Set Logo

Related Topics:

Question about Lionel Trains The Polar Express O Gauge Train Set

1 Answer

Forward and reverse switch

How do I make the engine go in reverse and pause

Posted by paul ohara on


1 Answer


  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 237 Answers

Are you using the transformer that came with the train set? This has forward, reverse, and neutral available?

Posted on Jan 20, 2014


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:


After system reset, how do I preset stations on my ux-d327b jvc hi-fi

You can only preset stations one by one. First, you can do a full scan for all stations in range. Press and hold the Stop button on the unit. Press Play/Pause to start the scan. (There are alternate methods using the remote control. See page 17 of the manual.) Press Fast Forward or Fast Reverse on the unit to navigate through the stations that have signal.

To set a preset, tune in a station using the Tune+/Tune- buttons on the remote or Fast Forward/Fast Reverse. Then press and hold Prog/Preset on the remote. When you see ##Empty or a preset number, use Tune+/Tune- to select one of the 20 preset storage numbers. Press OK/Play/Pause to save the preset. (If using the buttons on the unit, press Fast Forward/Fast Reverse to select a preset location. Press Play/Pause to save. You will see Stored on the display in either case, if you successfully saved the frequency to the location.

ManualsLib has the manual for the JVC UX-S327B here: . See page 18 for presetting stations.

I hope this helps.

Cindy Wells

John Deere Gator. Reverse works fine. Neither forward gear works.

Assume this is an electric vehicle?

The days of electric vehicles having a rheostat speed control and huge switches to change motor direction are far behind us.

Most modern electric vehicles employ a good deal of electronics with a switch mode power supply for speed regulation which controls hefty semiconductor devices. The forward/reverse switch would typically engage/disengage either relays or more semiconductor devices.

These devices are often placed on a common circuit board and any problems will need specialist investigation, repair or replacements. It is most unwise to reverse battery polarity when electronics are present - it is likely by doing so you have increased the repair cost...

Wireing diagram for a Zazzy 1100

I recently tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master.
It would'nt move forward or reverse, engine was good both solenoids for forward and reverse worked, but still couldn't diagnose the problem.
I don't have much technical knowledge but I just followed it step-wise, and now it works perfect! covers wiring, codes, diagrams, torque specs, PCV, everything
got it from

How do I work my Motorola Hitachi DV-P315 features without a remote?

Play / Pause is on the left (in your picture).
Stop is next to it,
Then Fast Reverse (hit more than once for even faster reverse)
Then Fast Forward (hit more than once for even faster forward)

How to rewind/fast forward trough currently listening segment?

Touch the screen, and 'reverse', 'pause', and 'forward' icons will momentarily appear on the lower portion of the screen. Before the icons vanish, touch either the forward or reverse icon and continue to hold your finger on the icon without lifting it off of the screen. Fast forward or rewind will then begin, at a rate of 5 seconds per second held. I am told after holding for 15 seconds or longer the speed of the fast forward may increase (true for other Coby models I have owned), but so far I have had no luck getting this to occur with my MP828.

Runs only in reverse i have other pre war 1681e does the same

Have you changed transformers? You can also make a Lionel run in opposite direction by using the throttle control...just go to stop and then to power and then back to no stop and right to power. That often works.
Not finding what you are looking for?


Ask a Question

Usually answered in minutes!

Top Lionel Crafts & Hobbies Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

55691 Answers

Tom Chichester

Level 3 Expert

62329 Answers

Carolyn Rogers

Level 2 Expert

145 Answers

Are you a Lionel Craft and Hobby Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides