I have the same problem on my nokia n70. i have uninstall all the files which i have installed, then i have switch off the mobile for several times. Now it has been working. remove u'r memory card and then switch on your mobile. by, Ilayaraja
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I see from your post that your Frigidaire washer is displaying a PAU code. Normally means the washer has been paused, which could be cleared be pressing either the cancel button or start button once. If that does not clear the code you could try resetting the appliance by disconnecting power. This could be done one of two ways by either unplugging the washer or flipping the household circuit breaker for ten minutes. Please comment back I would like to know if this information has been helpful. -Matt
I do not know any solution so far but try this if you want to use your camera like normal:
1. While in view/gallery mode, press and hold the view/gallery mode button. 2. press the shutter halfway. it should take you to shooting mode. remember to hold the view/gallery mode button. 3. use the camera as normal as long as you do not let go of the button.
to go to view/gallery mode: just press the shutter button halfway from shoot mode without pressing other buttons.
Sorry to read about your problem. this should be your E68 problem
You have a defective button on the control board. The best thing to do is go into the diagnostic mode. Turn the dial to Normal. Press and hold the Select and Pause/Cancel keys for 6 seconds, or until the Drying/Cool Down/Press Saver/Clean Lint Filter lights come on. Then press the Start and Pause/Cancel Buttons 4 seconds. This puts you into the diagnostic mode to check the keys. Now, turn the dial 4 O'clock position, or 75. This will allow you to check all your buttons. As you press each key, it will light all the lights above it. When you press a key and it does nothing or the lights above any certain key stays on without pushing it, this button is stuck. If you can't clear it, you probably have to replace the control board.
I tried to help you. Please help me and Vote/Rate this response. Thanks and good luck
Hi, The all in one solution software you used in XP doen't work with Vista.
But you can still scan and copy by using Windows Photo Gallery.
1. Click on files tab at the top in Window Photo Gallery.
2. Click on import from camera or scanner.
3. Highlight your scanner icon (ie HP f4280) then click import.
4. New scan window will popup, now you can preview or scan using this basic looking Vista utility.
I was just reading about a similar problem the other day. Make sure you don't have any of the buttons locked down in the pressed position.
Specifically, they were talking about the gallery review button, next to the camera shutter button on the right side of the phone, the one with the little PLAY arrow and the checkerboard pattern on it.
sir this is a typical problem when water seeps through the phone... may be the servicer havent cleaned it up well.once again ask him to clean it up well. my advice is change the keypads... it might prove helpful.. thank u sir