Question about Freezers

1 Answer

Problem with freezer

The temperature display is flashing almost continually. It is also making a clicking noise . The temperature display changes between -18 and -24. The food remains frozen.

Posted by paul140482 on

Ad

1 Answer

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 72 Answers
Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whirlpool freezer display flashing 1


Hi Rachel
For your door to close properly take off the gasket from your fridge and wash it with hot water. It will be softer and stick to the fridge much easier.

Feb 15, 2014 | Whirlpool 10 cu. ft. Chest Freezer...

1 Answer

Frigidaire freezer display flashing of and ff. I can't get it to do anything else.


Hello Aaron, thank you for allowing me to assist you!

Based on the symptoms you are describing it sounds like the temperature control is in the OFF position. When this occurs the temperature control turns off the compressor, but does not disconnect the power to the light bulb or other electronics. Let's try activating your freezer by pressing the UP arrow until display shows "4" or desired setting. Allow 24 hours for temperature to stabilize. For future reference you can lock the control to keep from accidently changing the temperature setting. I hope these troubleshooting tips help you in some small way. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if the unit's status has changed successfully.

Nov 30, 2013 | Frigidaire 20.3 Cu. Ft. Frost-Free Upright...

2 Answers

Lffh21f7hwa


Hello Michael - Sounds like the temperature control was accidently turned OFF. When this occurs the temperature control turns off the compressor, but does not disconnect the power to the light bulb or other electronics. Let's try activating the freezer by pressing the UP arrow until display shows "4" or desired setting. Allow 24 hours for temperature to stabilize. For future reference you can lock the control to keep from accidently changing the temperature setting. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if the unit's status has changed successfully. Thank you.

Jul 01, 2013 | Frigidaire 20.3 Cu. Ft. Frost-Free Upright...

1 Answer

Temperature display continuous flashing and continuous clicking noise


Aah, the favourite complaint. Basically, the display/ Main board will either need to be replaced or possibly reprogrammed. Fortunately i send my boards needing reprogramming to a friend to get done. Works extremly well after that. Careful not to let the clicking continue for long as the compressor will certainly malfunction.

Dec 18, 2011 | Whirlpool 19.6 cu. ft. Upright Freezer...

1 Answer

Temperature display flashing and continuous clicking noise


Your electronic board needs reprogramming or replacement. Very common with Whirlpool fridges.

Dec 18, 2011 | Whirlpool 19.6 cu. ft. Upright Freezer...

1 Answer

Alarm keeps going off


Alarm will sound if the temperature of the freezer rises to unsafe levels. An indicator light will flash and continue to flash until the temperature reaches a safe level. The buzzer will also sound and will continue for 48 hours unless a safe condition exists.

Dec 14, 2010 | Kenmore Freezers

1 Answer

After power cut the temperature of the fridge and the freezer termperature are just flashing and making a beeping noise


It means the compartment temperatures are increased then allowed limit.Generally in some appliances the maximum temperature is indicated at the display with an alarm after the electric cutoff.If the temp is high in the compartments

Jun 29, 2009 | Whirlpool Freezers

1 Answer

Interior fridge fan continues to ice up


hello when you put the back panel to the refrigerator section back on did you notice that there was any stryofoam missing or broken on the cover? Had one do the exact same thing and what I found was that when the pevious person took the panel off the stryofoam some how broke and the air flow would bypass the coil causing it to freeze up after a while, also when I took it apart all of the screws were not in the cover further compounding the problem. I repaired and reassembled and it has been working great ever since.

Dec 26, 2008 | Freezers

1 Answer

Digital temperature buttons on upright freezer


Hi penshesh,
Happy to help.
This is the model # AFG7060
I would advise you on this occasion to call service.

These guys are good!
A&E factory service does most brands warranty services.
They are open 7days/24hours nation wide.
call tonight! 1-800-905-9505

I am happy to assist you!
Neil
PS. Before you leave this site please leave a "Problem Solved" rating for me on fixya.com

Aug 22, 2008 | Freezers

1 Answer

Cannot control internal temp plus clicking relay on control panel.


Where is the fast defrost button on Kenmore chest freezers?

Nov 20, 2007 | Freezers

Not finding what you are looking for?
Freezers Logo

Related Topics:

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Freezers Experts

Dennis Boxerman

Level 3 Expert

1300 Answers

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Marvin
Marvin

Level 3 Expert

85231 Answers

Are you a Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...